[PATCH v5 5/9] drm/bridge: anx7625: Add typec_mux_set callback function

[Prashant Malani]

On Thu, Jun 30, 2022 at 4:38 PM Prashant Malani <pmalani at chromium.org> wrote:
>
> On Thu, Jun 30, 2022 at 4:21 PM Stephen Boyd <swboyd at chromium.org> wrote:
> >
> > Quoting Prashant Malani (2022-06-28 13:56:22)
> > > On Tue, Jun 28, 2022 at 1:40 PM Stephen Boyd <swboyd at chromium.org> wrote:
> > > >
> > > > I suppose none of those things matter though as long as there is some
> > > > typec switch registered here so that the driver can be informed of the
> > > > pin assignment. Is it right that the "mode-switch" property is only
> > > > required in DT if this device is going to control the mode of the
> > > > connector, i.e. USB+DP, or just DP? Where this device can't do that
> > > > because it doesn't support only DP.
> > >
> > > If the anx7625 is used just to route all lanes from 1 usb-c-connector (i.e
> > > the USB+DP case), a mode-switch wouldn't be of much use, since one
> > > would also route the CC lines to the built-in PD controller; so it will
> > > already have knowledge of what mode the switch is in.
> > >
> > > The mode-switch is likely only relevant for this hardware configuration(
> > > it's "DP only" in the sense that the USB pins to the SoC never go anywhere).
> > > One only has 2 SS lanes each (from each usb-c-connector).
> > >
> > > Since there is no CC-line, the anx7625 needs to know which one has DP
> > > enabled on it.
> >
> > Can the CC line be "captured" and not actually sent to the anx7625?
>
> That's what happens on Chrome OS. The cc line goes to the EC (and is "consumed"
> by the TCPM (Type C Port Manager)) and signals are then sent to the AP
> over the Host command interface to `cros-ec-typec`. The signals here being all
> the PD messages communicated between the peripheral and the port.
>
> > I imagine if that is possible, maybe the CC lines would go to some
> > micro-controller or something that did more typec management things and
> > then the anx7625 driver would need to do software control of the mode
> > and orientation control.
>
> I _guess_ that is possible (though it would seem odd to not use all the PD
> control hardware in that configuration)? If an system implements it in
> such a way
> then:
> 1. mode-switch: Can be updated to do something when num_typec_switches == 1 (
> in the mux_set function imp.l I haven't looked into what registers
> need to be configured, since we
> don't have this hardware implementation.
> 2. orientation-switch: This should be registered, and then flip the
> lanes when the port
> driver tells it the orientation is one way or another.
>
> So, if someone uses it that way, I think the driver needs only minor
> updates to support it.

Stephen, any pending concerns?
If not,I will post a v6 series with the suggested changes:
- Drop typec-switch binding; instead add a new top-level port with
end-points for each Type-C connector's switch.
- Drop it6505 patches.
- Squash anx7625 driver patches into one patch.
- Add a comment mentioning that we aren't registering the orientation-switch.