[PATCH v11 05/10] drm/mediatek: Add MT8195 Embedded DisplayPort driver
CK Hu
ck.hu at mediatek.com
Mon Jun 20 03:12:55 UTC 2022
On Fri, 2022-06-10 at 18:55 +0800, Bo-Chen Chen wrote:
> From: Markus Schneider-Pargmann <msp at baylibre.com>
>
> This patch adds a embedded displayport driver for the MediaTek mt8195
> SoC.
>
> It supports the MT8195, the embedded DisplayPort units. It offers
> DisplayPort 1.4 with up to 4 lanes.
>
> The driver creates a child device for the phy. The child device will
> never exist without the parent being active. As they are sharing a
> register range, the parent passes a regmap pointer to the child so
> that
> both can work with the same register range. The phy driver sets
> device
> data that is read by the parent to get the phy device that can be
> used
> to control the phy properties.
>
> This driver is based on an initial version by
> Jitao shi <jitao.shi at mediatek.com>
>
> Signed-off-by: Markus Schneider-Pargmann <msp at baylibre.com>
> Signed-off-by: Guillaume Ranquet <granquet at baylibre.com>
> [Bo-Chen: Cleanup the drivers and modify comments from reviewers]
> Signed-off-by: Bo-Chen Chen <rex-bc.chen at mediatek.com>
> ---
[snip]
> +
> +static void mtk_dp_calculate_pixrate(struct mtk_dp *mtk_dp)
> +{
> + u8 target_frame_rate = 60;
> + u32 target_pixel_clk;
> + struct drm_display_mode mode;
> + struct mtk_dp_timings *timings = &mtk_dp->info.timings;
> +
> + drm_display_mode_from_videomode(&timings->vm, &mode);
> +
> + if (mtk_dp->info.timings.frame_rate > 0) {
> + target_frame_rate = mtk_dp->info.timings.frame_rate;
> + target_pixel_clk = mode.htotal * mode.vtotal *
> + target_frame_rate;
> + } else if (mtk_dp->info.timings.pix_rate_khz > 0) {
> + target_pixel_clk = mtk_dp->info.timings.pix_rate_khz *
> 1000;
> + } else {
> + target_pixel_clk = mode.htotal * mode.vtotal *
> + target_frame_rate;
> + }
> +
> + mtk_dp->info.timings.pix_rate_khz = target_pixel_clk / 1000;
It seems that pix_rate_khz is used only here and does not used in
another place, so pix_rate_khz is useless, remove it.
Regards,
CK
> +}
> +
More information about the dri-devel
mailing list