[PATCH v4 2/4] arm64/dts/qcom/sc7180: remove assigned-clock-rate property for mdp clk

[Vinod Polimera]

Kernel clock driver assumes that initial rate is the
max rate for that clock and was not allowing it to scale
beyond the assigned clock value.

Drop the assigned clock rate property and vote on the mdp clock as per
calculated value during the usecase.

Fixes: a3db7ad1af("arm64: dts: qcom: sc7180: add display dt nodes")
Signed-off-by: Vinod Polimera <quic_vpolimer at quicinc.com>
---
 arch/arm64/boot/dts/qcom/sc7180.dtsi | 9 ++-------
 1 file changed, 2 insertions(+), 7 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/sc7180.dtsi b/arch/arm64/boot/dts/qcom/sc7180.dtsi
index e1c46b8..eaab746 100644
--- a/arch/arm64/boot/dts/qcom/sc7180.dtsi
+++ b/arch/arm64/boot/dts/qcom/sc7180.dtsi
@@ -2900,9 +2900,6 @@
 				 <&dispcc DISP_CC_MDSS_MDP_CLK>;
 			clock-names = "iface", "ahb", "core";
 
-			assigned-clocks = <&dispcc DISP_CC_MDSS_MDP_CLK>;
-			assigned-clock-rates = <300000000>;
-
 			interrupts = <GIC_SPI 83 IRQ_TYPE_LEVEL_HIGH>;
 			interrupt-controller;
 			#interrupt-cells = <1>;
@@ -2932,12 +2929,10 @@
 					 <&dispcc DISP_CC_MDSS_VSYNC_CLK>;
 				clock-names = "bus", "iface", "rot", "lut", "core",
 					      "vsync";
-				assigned-clocks = <&dispcc DISP_CC_MDSS_MDP_CLK>,
-						  <&dispcc DISP_CC_MDSS_VSYNC_CLK>,
+				assigned-clocks = <&dispcc DISP_CC_MDSS_VSYNC_CLK>,
 						  <&dispcc DISP_CC_MDSS_ROT_CLK>,
 						  <&dispcc DISP_CC_MDSS_AHB_CLK>;
-				assigned-clock-rates = <300000000>,
-						       <19200000>,
+				assigned-clock-rates = <19200000>,
 						       <19200000>,
 						       <19200000>;
 				operating-points-v2 = <&mdp_opp_table>;
-- 
2.7.4