drm/bridge: anx7625: Set downstream sink into normal status

[Pin-yen Lin]

Hi Xin,

Can we use dev_dbg instead of dev_info for the logging?

The log here is more like a debugging message, and using dev_dbg makes
it consistent with anx7625_dp_stop.

Sorry for not catching this earlier.

Best regards,
Pin-yen

On Thu, Mar 3, 2022 at 3:52 PM Pin-yen Lin <treapking at chromium.org> wrote:
>
> Reviewed-by: Pin-Yen Lin <treapking at chromium.org>
>
>
> On Wed, Mar 2, 2022 at 8:09 PM Xin Ji <xji at analogixsemi.com> wrote:
> >
> > As downstream sink was set into standby mode while bridge disabled,
> > this patch used for setting downstream sink into normal status
> > while enable bridge.
> >
> > Signed-off-by: Xin Ji <xji at analogixsemi.com>
> > ---
> >  drivers/gpu/drm/bridge/analogix/anx7625.c | 8 ++++++++
> >  1 file changed, 8 insertions(+)
> >
> > diff --git a/drivers/gpu/drm/bridge/analogix/anx7625.c b/drivers/gpu/drm/bridge/analogix/anx7625.c
> > index 9aab879a8851..963eaf73ecab 100644
> > --- a/drivers/gpu/drm/bridge/analogix/anx7625.c
> > +++ b/drivers/gpu/drm/bridge/analogix/anx7625.c
> > @@ -919,12 +919,20 @@ static void anx7625_dp_start(struct anx7625_data *ctx)
> >  {
> >         int ret;
> >         struct device *dev = &ctx->client->dev;
> > +       u8 data;
> >
> >         if (!ctx->display_timing_valid) {
> >                 DRM_DEV_ERROR(dev, "mipi not set display timing yet.\n");
> >                 return;
> >         }
> >
> > +       dev_info(dev, "set downstream sink into normal\n");
> > +       /* Downstream sink enter into normal mode */
> > +       data = 1;
> > +       ret = anx7625_aux_trans(ctx, DP_AUX_NATIVE_WRITE, 0x000600, 1, &data);
> > +       if (ret < 0)
> > +               dev_err(dev, "IO error : set sink into normal mode fail\n");
> > +
> >         /* Disable HDCP */
> >         anx7625_write_and(ctx, ctx->i2c.rx_p1_client, 0xee, 0x9f);
> >