[PATCH v5 07/13] drm/msm/disp/dpu1: Add support for DSC in encoder
Vinod Koul
vkoul at kernel.org
Fri Mar 25 11:05:50 UTC 2022
We need to configure the encoder for DSC configuration and calculate DSC
parameters for the given timing so this patch adds that support by
adding dpu_encoder_prep_dsc() which is invoked when DSC is enabled.
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
Reviewed-by: Abhinav Kumar <quic_abhinavk at quicinc.com>
Signed-off-by: Vinod Koul <vkoul at kernel.org>
---
drivers/gpu/drm/msm/disp/dpu1/dpu_encoder.c | 126 +++++++++++++++++-
.../gpu/drm/msm/disp/dpu1/dpu_encoder_phys.h | 8 ++
2 files changed, 133 insertions(+), 1 deletion(-)
diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder.c
index 1e648db439f9..2219dbfa5ee7 100644
--- a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder.c
+++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder.c
@@ -21,6 +21,7 @@
#include "dpu_hw_intf.h"
#include "dpu_hw_ctl.h"
#include "dpu_hw_dspp.h"
+#include "dpu_hw_dsc.h"
#include "dpu_formats.h"
#include "dpu_encoder_phys.h"
#include "dpu_crtc.h"
@@ -136,6 +137,8 @@ enum dpu_enc_rc_states {
* @cur_slave: As above but for the slave encoder.
* @hw_pp: Handle to the pingpong blocks used for the display. No.
* pingpong blocks can be different than num_phys_encs.
+ * @hw_dsc: Handle to the DSC blocks used for the display.
+ * @dsc_mask: Bitmask of used DSC blocks.
* @intfs_swapped: Whether or not the phys_enc interfaces have been swapped
* for partial update right-only cases, such as pingpong
* split where virtual pingpong does not generate IRQs
@@ -169,6 +172,7 @@ enum dpu_enc_rc_states {
* @topology: topology of the display
* @idle_timeout: idle timeout duration in milliseconds
* @dp: msm_dp pointer, for DP encoders
+ * @dsc: msm_display_dsc_config pointer, for DSC-enabled encoders
*/
struct dpu_encoder_virt {
struct drm_encoder base;
@@ -182,6 +186,9 @@ struct dpu_encoder_virt {
struct dpu_encoder_phys *cur_master;
struct dpu_encoder_phys *cur_slave;
struct dpu_hw_pingpong *hw_pp[MAX_CHANNELS_PER_ENC];
+ struct dpu_hw_dsc *hw_dsc[MAX_CHANNELS_PER_ENC];
+
+ unsigned int dsc_mask;
bool intfs_swapped;
@@ -209,6 +216,9 @@ struct dpu_encoder_virt {
u32 idle_timeout;
struct msm_dp *dp;
+
+ /* DSC configuration */
+ struct msm_display_dsc_config *dsc;
};
#define to_dpu_encoder_virt(x) container_of(x, struct dpu_encoder_virt, base)
@@ -972,7 +982,9 @@ static void dpu_encoder_virt_mode_set(struct drm_encoder *drm_enc,
struct dpu_hw_blk *hw_ctl[MAX_CHANNELS_PER_ENC];
struct dpu_hw_blk *hw_lm[MAX_CHANNELS_PER_ENC];
struct dpu_hw_blk *hw_dspp[MAX_CHANNELS_PER_ENC] = { NULL };
- int num_lm, num_ctl, num_pp;
+ struct dpu_hw_blk *hw_dsc[MAX_CHANNELS_PER_ENC];
+ int num_lm, num_ctl, num_pp, num_dsc;
+ unsigned int dsc_mask = 0;
int i, j;
if (!drm_enc) {
@@ -1027,6 +1039,18 @@ static void dpu_encoder_virt_mode_set(struct drm_encoder *drm_enc,
dpu_enc->hw_pp[i] = i < num_pp ? to_dpu_hw_pingpong(hw_pp[i])
: NULL;
+ if (dpu_enc->dsc) {
+ num_dsc = dpu_rm_get_assigned_resources(&dpu_kms->rm, global_state,
+ drm_enc->base.id, DPU_HW_BLK_DSC,
+ hw_dsc, ARRAY_SIZE(hw_dsc));
+ for (i = 0; i < num_dsc; i++) {
+ dpu_enc->hw_dsc[i] = to_dpu_hw_dsc(hw_dsc[i]);
+ dsc_mask |= BIT(dpu_enc->hw_dsc[i]->idx - DSC_0);
+ }
+ }
+
+ dpu_enc->dsc_mask = dsc_mask;
+
cstate = to_dpu_crtc_state(drm_crtc->state);
for (i = 0; i < num_lm; i++) {
@@ -1739,6 +1763,93 @@ static void dpu_encoder_vsync_event_work_handler(struct kthread_work *work)
nsecs_to_jiffies(ktime_to_ns(wakeup_time)));
}
+static void
+dpu_encoder_dsc_initial_line_calc(struct msm_display_dsc_config *dsc,
+ u32 enc_ip_width)
+{
+ int ssm_delay, total_pixels, soft_slice_per_enc;
+
+ soft_slice_per_enc = enc_ip_width / dsc->drm->slice_width;
+
+ /*
+ * minimum number of initial line pixels is a sum of:
+ * 1. sub-stream multiplexer delay (83 groups for 8bpc,
+ * 91 for 10 bpc) * 3
+ * 2. for two soft slice cases, add extra sub-stream multiplexer * 3
+ * 3. the initial xmit delay
+ * 4. total pipeline delay through the "lock step" of encoder (47)
+ * 5. 6 additional pixels as the output of the rate buffer is
+ * 48 bits wide
+ */
+ ssm_delay = ((dsc->drm->bits_per_component < 10) ? 84 : 92);
+ total_pixels = ssm_delay * 3 + dsc->drm->initial_xmit_delay + 47;
+ if (soft_slice_per_enc > 1)
+ total_pixels += (ssm_delay * 3);
+ dsc->initial_lines = DIV_ROUND_UP(total_pixels, dsc->drm->slice_width);
+}
+
+static void dpu_encoder_dsc_pipe_cfg(struct dpu_hw_dsc *hw_dsc,
+ struct dpu_hw_pingpong *hw_pp,
+ struct msm_display_dsc_config *dsc,
+ u32 common_mode)
+{
+ if (hw_dsc->ops.dsc_config)
+ hw_dsc->ops.dsc_config(hw_dsc, dsc, common_mode);
+
+ if (hw_dsc->ops.dsc_config_thresh)
+ hw_dsc->ops.dsc_config_thresh(hw_dsc, dsc);
+
+ if (hw_pp->ops.setup_dsc)
+ hw_pp->ops.setup_dsc(hw_pp);
+
+ if (hw_pp->ops.enable_dsc)
+ hw_pp->ops.enable_dsc(hw_pp);
+}
+
+static void dpu_encoder_prep_dsc(struct dpu_encoder_virt *dpu_enc,
+ struct msm_display_dsc_config *dsc)
+{
+ /* coding only for 2LM, 2enc, 1 dsc config */
+ struct dpu_encoder_phys *enc_master = dpu_enc->cur_master;
+ struct dpu_hw_dsc *hw_dsc[MAX_CHANNELS_PER_ENC];
+ struct dpu_hw_pingpong *hw_pp[MAX_CHANNELS_PER_ENC];
+ int this_frame_slices;
+ int intf_ip_w, enc_ip_w;
+ int dsc_common_mode;
+ int pic_width;
+ int i;
+
+ for (i = 0; i < MAX_CHANNELS_PER_ENC; i++) {
+ hw_pp[i] = dpu_enc->hw_pp[i];
+ hw_dsc[i] = dpu_enc->hw_dsc[i];
+
+ if (!hw_pp[i] || !hw_dsc[i]) {
+ DPU_ERROR_ENC(dpu_enc, "invalid params for DSC\n");
+ return;
+ }
+ }
+
+ dsc_common_mode = 0;
+ pic_width = dsc->drm->pic_width;
+
+ dsc_common_mode = DSC_MODE_MULTIPLEX | DSC_MODE_SPLIT_PANEL;
+ if (enc_master->intf_mode == INTF_MODE_VIDEO)
+ dsc_common_mode |= DSC_MODE_VIDEO;
+
+ this_frame_slices = pic_width / dsc->drm->slice_width;
+ intf_ip_w = this_frame_slices * dsc->drm->slice_width;
+
+ /*
+ * dsc merge case: when using 2 encoders for the same stream,
+ * no. of slices need to be same on both the encoders.
+ */
+ enc_ip_w = intf_ip_w / 2;
+ dpu_encoder_dsc_initial_line_calc(dsc, enc_ip_w);
+
+ for (i = 0; i < MAX_CHANNELS_PER_ENC; i++)
+ dpu_encoder_dsc_pipe_cfg(hw_dsc[i], hw_pp[i], dsc, dsc_common_mode);
+}
+
void dpu_encoder_prepare_for_kickoff(struct drm_encoder *drm_enc)
{
struct dpu_encoder_virt *dpu_enc;
@@ -1770,6 +1881,9 @@ void dpu_encoder_prepare_for_kickoff(struct drm_encoder *drm_enc)
dpu_encoder_helper_hw_reset(dpu_enc->phys_encs[i]);
}
}
+
+ if (dpu_enc->dsc)
+ dpu_encoder_prep_dsc(dpu_enc, dpu_enc->dsc);
}
void dpu_encoder_kickoff(struct drm_encoder *drm_enc)
@@ -2015,6 +2129,8 @@ static int dpu_encoder_setup_display(struct dpu_encoder_virt *dpu_enc,
dpu_enc->idle_pc_supported =
dpu_kms->catalog->caps->has_idle_pc;
+ dpu_enc->dsc = disp_info->dsc;
+
mutex_lock(&dpu_enc->enc_lock);
for (i = 0; i < disp_info->num_of_h_tiles && !ret; i++) {
/*
@@ -2244,3 +2360,11 @@ enum dpu_intf_mode dpu_encoder_get_intf_mode(struct drm_encoder *encoder)
return INTF_MODE_NONE;
}
+
+unsigned int dpu_encoder_helper_get_dsc(struct dpu_encoder_phys *phys_enc)
+{
+ struct drm_encoder *encoder = phys_enc->parent;
+ struct dpu_encoder_virt *dpu_enc = to_dpu_encoder_virt(encoder);
+
+ return dpu_enc->dsc_mask;
+}
diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys.h b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys.h
index e7270eb6b84b..7b90d644a41b 100644
--- a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys.h
+++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys.h
@@ -332,6 +332,14 @@ static inline enum dpu_3d_blend_mode dpu_encoder_helper_get_3d_blend_mode(
return BLEND_3D_NONE;
}
+/**
+ * dpu_encoder_helper_get_dsc - get DSC blocks mask for the DPU encoder
+ * This helper function is used by physical encoder to get DSC blocks mask
+ * used for this encoder.
+ * @phys_enc: Pointer to physical encoder structure
+ */
+unsigned int dpu_encoder_helper_get_dsc(struct dpu_encoder_phys *phys_enc);
+
/**
* dpu_encoder_helper_split_config - split display configuration helper function
* This helper function may be used by physical encoders to configure
--
2.34.1
More information about the dri-devel
mailing list