[PATCH] dt-bindings: display: msm: dsi: remove address/size cells

[Vinod Koul]

On 29-03-22, 10:52, Rob Herring wrote:
> On Tue, Mar 29, 2022 at 12:01:52PM +0530, Vinod Koul wrote:
> > On 28-03-22, 13:21, Rob Herring wrote:
> > > On Mon, Mar 28, 2022 at 12:18 PM Krzysztof Kozlowski
> > > <krzysztof.kozlowski at linaro.org> wrote:
> > > >
> > > > On 28/03/2022 19:16, Vinod Koul wrote:
> > > > > On 28-03-22, 19:43, Dmitry Baryshkov wrote:
> > > > >> On Mon, 28 Mar 2022 at 18:30, Krzysztof Kozlowski
> > > > >> <krzysztof.kozlowski at linaro.org> wrote:
> > > > >>>
> > > > >>> The DSI node is not a bus and the children do not have unit addresses.
> > > > >>>
> > > > >>> Reported-by: Vinod Koul <vkoul at kernel.org>
> > > > >>> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski at linaro.org>
> > > > >>
> > > > >> NAK.
> > > > >> DSI panels are children of the DSI device tree node with the reg = <0>; address.
> > > > >> This is the convention used by other platforms too (see e.g.
> > > > >> arch/arm64/boot/dts/freescale/imx8mq-evk.dts).
> > > > >
> > > > > So we should add reg = 0, i will update my dtsi fix
> > > > >
> > > >
> > > > To "ports" node? No. The reg=0 is for children of the bus, so the
> > > > panels. How to combine both without warnings - ports and panel at 0 - I
> > > > don't know yet...
> > > 
> > > I don't think that should case a warning. Or at least it's one we turn off.
> > 
> > Well in this case I think we might need a fix:
> > Here is the example quoted in the binding. We have ports{} and then the
> > two port at 0 and port at 1 underneath.
> 
> It's the #address-cells/#size-cells under 'ports' that applies to 'port' 
> nodes. As 'ports' has no address (reg) itself, it doesn't need 
> #address-cells/#size-cells in its parent node.
> 
> > 
> > So it should be okay to drop #address-cells/#size-cells from dsi node
> > but keep in ports node...
> 
> Yes.
> 
> > Thoughts...?
> 
> But I thought a panel at 0 node was being added? If so then you need to add 
> them back.

I guess we should make this optional, keep it when adding panel at 0 node
and skip for rest where not applicable..? Dmitry is that fine with you?

-- 
~Vinod