(EXT) [PATCH 5/6] dt-bindings: drm/bridge: ti-sn65dsi83: Add reset controller documentation

[Marco Felsch]

Hi Alexander,

On 22-05-31, Alexander Stein wrote:
> Hi Marco,
> 
> Am Montag, 30. Mai 2022, 17:05:48 CEST schrieb Marco Felsch:
> > The bridge device can now also be enabled/disabled by an external reset
> > controller. So the device now supports either enable/disable by simple
> > GPIO or by an Reset-Controller.
> > 
> > Signed-off-by: Marco Felsch <m.felsch at pengutronix.de>
> > ---
> >  .../devicetree/bindings/display/bridge/ti,sn65dsi83.yaml    | 6 ++++++
> >  1 file changed, 6 insertions(+)
> > 
> > diff --git
> > a/Documentation/devicetree/bindings/display/bridge/ti,sn65dsi83.yaml
> > b/Documentation/devicetree/bindings/display/bridge/ti,sn65dsi83.yaml index
> > 7306b9874dc3..eff8360c184e 100644
> > --- a/Documentation/devicetree/bindings/display/bridge/ti,sn65dsi83.yaml
> > +++ b/Documentation/devicetree/bindings/display/bridge/ti,sn65dsi83.yaml
> > @@ -35,6 +35,12 @@ properties:
> >    vcc-supply:
> >      description: A 1.8V power supply (see regulator/regulator.yaml).
> > 
> > +  resets:
> > +    maxItems: 1
> > +    description: |
> > +      Reset specifier for bridge_en pin. This is required only if the
> > brdige_en +      pin is connected to a reset controller.
> > +
> >    ports:
> >      $ref: /schemas/graph.yaml#/properties/ports
> 
> Maybe it should be added here, that 'resets' is an alternative to 'enable-
> gpios' as both are essentially controlling the same pin from the bridge.

I mention the bridge_en pin two times :) But I could also add that this
is an alternative to the enable-gpios. Maybe it even more clear than.

Regards,
  Marco

> 
> Best regards
> Alexander
> 
> 
>