[PATCH] drm/bridge: ti-sn65dsi86: Fix output polarity setting bug

[Qiqi Zhang]

According to the description in ti-sn65dsi86's datasheet:

CHA_HSYNC_POLARITY:
0 = Active High Pulse. Synchronization signal is high for the sync
pulse width. (default)
1 = Active Low Pulse. Synchronization signal is low for the sync
pulse width.

CHA_VSYNC_POLARITY:
0 = Active High Pulse. Synchronization signal is high for the sync
pulse width. (Default)
1 = Active Low Pulse. Synchronization signal is low for the sync
pulse width.

We should only set these bits when the polarity is negative.
Signed-off-by: Qiqi Zhang <eddy.zhang at rock-chips.com>
---
 drivers/gpu/drm/bridge/ti-sn65dsi86.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/bridge/ti-sn65dsi86.c b/drivers/gpu/drm/bridge/ti-sn65dsi86.c
index 3c3561942eb6..eb24322df721 100644
--- a/drivers/gpu/drm/bridge/ti-sn65dsi86.c
+++ b/drivers/gpu/drm/bridge/ti-sn65dsi86.c
@@ -931,9 +931,9 @@ static void ti_sn_bridge_set_video_timings(struct ti_sn65dsi86 *pdata)
 		&pdata->bridge.encoder->crtc->state->adjusted_mode;
 	u8 hsync_polarity = 0, vsync_polarity = 0;
 
-	if (mode->flags & DRM_MODE_FLAG_PHSYNC)
+	if (mode->flags & DRM_MODE_FLAG_NHSYNC)
 		hsync_polarity = CHA_HSYNC_POLARITY;
-	if (mode->flags & DRM_MODE_FLAG_PVSYNC)
+	if (mode->flags & DRM_MODE_FLAG_NVSYNC)
 		vsync_polarity = CHA_VSYNC_POLARITY;
 
 	ti_sn65dsi86_write_u16(pdata, SN_CHA_ACTIVE_LINE_LENGTH_LOW_REG,
-- 
2.25.1