[PATCH 4/4] dt-bindings: display: panel: mipi-dbi-spi: Add io-supply

[Otto Pflüger]

Add the new io-supply property, which specifies the regulator for
the I/O voltage supply on platforms where the panel panel power and
I/O supplies are separate.

Signed-off-by: Otto Pflüger <affenull2345 at gmail.com>
---
  .../bindings/display/panel/panel-mipi-dbi-spi.yaml        | 8 +++++++-
  1 file changed, 7 insertions(+), 1 deletion(-)

diff --git 
a/Documentation/devicetree/bindings/display/panel/panel-mipi-dbi-spi.yaml 
b/Documentation/devicetree/bindings/display/panel/panel-mipi-dbi-spi.yaml
index d55bf12ecead..68cbdfab5438 100644
--- 
a/Documentation/devicetree/bindings/display/panel/panel-mipi-dbi-spi.yaml
+++ 
b/Documentation/devicetree/bindings/display/panel/panel-mipi-dbi-spi.yaml
@@ -22,8 +22,9 @@ description: |
    The standard defines the following interface signals for type C:
    - Power:
      - Vdd: Power supply for display module
+      Called power-supply in this binding.
      - Vddi: Logic level supply for interface signals
-    Combined into one in this binding called: power-supply
+      Called io-supply in this binding.
    - Interface:
      - CSx: Chip select
      - SCL: Serial clock
@@ -80,6 +81,11 @@ properties:
        Controller data/command selection (D/CX) in 4-line SPI mode.
        If not set, the controller is in 3-line SPI mode.

+  io-supply:
+    description: |
+      Logic level supply for interface signals (Vddi).
+      No need to set if this is the same as power-supply.
+
    power-supply:
      description: Power supply for the display module (Vdd).

-- 
2.30.2