[PATCH v7 05/10] drm: bridge: samsung-dsim: Add atomic_check

[Marek Vasut]

On 10/5/22 17:13, Jagan Teki wrote:
> Look like an explicit fixing up of mode_flags is required for DSIM IP
> present in i.MX8M Mini/Nano SoCs.
> 
> At least the LCDIF + DSIM needs active low sync polarities in order
> to correlate the correct sync flags of the surrounding components in
> the chain to make sure the whole pipeline can work properly.
> 
> On the other hand the i.MX 8M Mini Applications Processor Reference Manual,
> Rev. 3, 11/2020 says.
> "13.6.3.5.2 RGB interface
>   Vsync, Hsync, and VDEN are active high signals."
> 
> No clear evidence about whether it can be documentation issues or
> something, so added a comment FIXME for this and updated the active low
> sync polarities using SAMSUNG_DSIM_TYPE_IMX8MM hw_type.

[...]

> +static int samsung_dsim_atomic_check(struct drm_bridge *bridge,
> +				     struct drm_bridge_state *bridge_state,
> +				     struct drm_crtc_state *crtc_state,
> +				     struct drm_connector_state *conn_state)
> +{
> +	struct samsung_dsim *dsi = bridge_to_dsi(bridge);
> +	struct drm_display_mode *adjusted_mode = &crtc_state->adjusted_mode;
> +
> +	if (dsi->plat_data->hw_type == SAMSUNG_DSIM_TYPE_IMX8MM) {
> +		/**
> +		 * FIXME:
> +		 * At least LCDIF + DSIM needs active low sync,
> +		 * but i.MX 8M Mini Applications Processor Reference Manual,
> +		 * Rev. 3, 11/2020 says
> +		 *
> +		 * 13.6.3.5.2 RGB interface
> +		 * Vsync, Hsync, and VDEN are active high signals.
> +		 */
> +		adjusted_mode->flags |= (DRM_MODE_FLAG_NHSYNC | DRM_MODE_FLAG_NVSYNC);
> +		adjusted_mode->flags &= ~(DRM_MODE_FLAG_PHSYNC | DRM_MODE_FLAG_PVSYNC);
> +	}

It would be good to explain what exactly is going on here in the 
comment, the comment says "Vsync, Hsync, and VDEN are active high 
signals." and the code below does exact opposite and sets NxSYNC flags.

Yes, the MX8MM/MN does need HS/VS/DE active LOW, it is a quirk of that 
MXSFB-DSIM glue logic. The MX8MP needs the exact opposite on all three, 
active HIGH.

It would also be good to mention both MX8MM and MX8MN are affected, not 
only MX8MM.