[PATCH v4 12/12] drm/i915/dsc: make use of several params from drm_dsc_config

[Dmitry Baryshkov]

The code was ignoring (up to some point for rc_model_size) the
rc_model_size, rc_tgt_offset_high, rc_tgt_offset_low and rc_edge_factor
parameters from struct drm_dsc_config. Actually use them instead of
resorting to predefined constants.

Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
---
 drivers/gpu/drm/i915/display/intel_vdsc.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/gpu/drm/i915/display/intel_vdsc.c b/drivers/gpu/drm/i915/display/intel_vdsc.c
index 2d4917ca1f14..76d956a01e2d 100644
--- a/drivers/gpu/drm/i915/display/intel_vdsc.c
+++ b/drivers/gpu/drm/i915/display/intel_vdsc.c
@@ -89,7 +89,7 @@ calculate_rc_params(struct drm_dsc_config *vdsc_cfg)
 		vdsc_cfg->initial_offset = 6144;
 
 	/* initial_xmit_delay = rc_model_size/2/compression_bpp */
-	vdsc_cfg->initial_xmit_delay = DIV_ROUND_UP(DSC_RC_MODEL_SIZE_CONST, 2 * bpp);
+	vdsc_cfg->initial_xmit_delay = DIV_ROUND_UP(vdsc_cfg->rc_model_size, 2 * bpp);
 
 	vdsc_cfg->flatness_min_qp = 3 + qp_bpc_modifier;
 	vdsc_cfg->flatness_max_qp = 12 + qp_bpc_modifier;
@@ -543,7 +543,7 @@ static void intel_dsc_pps_configure(const struct intel_crtc_state *crtc_state)
 	/* Populate PICTURE_PARAMETER_SET_9 registers */
 	pps_val = 0;
 	pps_val |= DSC_RC_MODEL_SIZE(vdsc_cfg->rc_model_size) |
-		DSC_RC_EDGE_FACTOR(DSC_RC_EDGE_FACTOR_CONST);
+		DSC_RC_EDGE_FACTOR(vdsc_cfg->rc_edge_factor);
 	drm_dbg_kms(&dev_priv->drm, "PPS9 = 0x%08x\n", pps_val);
 	if (!is_pipe_dsc(crtc, cpu_transcoder)) {
 		intel_de_write(dev_priv, DSCA_PICTURE_PARAMETER_SET_9,
@@ -569,8 +569,8 @@ static void intel_dsc_pps_configure(const struct intel_crtc_state *crtc_state)
 	pps_val = 0;
 	pps_val |= DSC_RC_QUANT_INC_LIMIT0(vdsc_cfg->rc_quant_incr_limit0) |
 		DSC_RC_QUANT_INC_LIMIT1(vdsc_cfg->rc_quant_incr_limit1) |
-		DSC_RC_TARGET_OFF_HIGH(DSC_RC_TGT_OFFSET_HI_CONST) |
-		DSC_RC_TARGET_OFF_LOW(DSC_RC_TGT_OFFSET_LO_CONST);
+		DSC_RC_TARGET_OFF_HIGH(vdsc_cfg->rc_tgt_offset_high) |
+		DSC_RC_TARGET_OFF_LOW(vdsc_cfg->rc_tgt_offset_low);
 	drm_dbg_kms(&dev_priv->drm, "PPS10 = 0x%08x\n", pps_val);
 	if (!is_pipe_dsc(crtc, cpu_transcoder)) {
 		intel_de_write(dev_priv, DSCA_PICTURE_PARAMETER_SET_10,
-- 
2.39.2