[PATCH] drm/amd/pm: Clean up errors in vega12_hwmgr.c

Ran Sun sunran001 at 208suo.com
Tue Aug 1 02:57:03 UTC 2023


Fix the following errors reported by checkpatch:

ERROR: need consistent spacing around '/' (ctx:WxV)
ERROR: code indent should use tabs where possible

Signed-off-by: Ran Sun <sunran001 at 208suo.com>
---
 drivers/gpu/drm/amd/pm/powerplay/hwmgr/vega12_hwmgr.c | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/drivers/gpu/drm/amd/pm/powerplay/hwmgr/vega12_hwmgr.c b/drivers/gpu/drm/amd/pm/powerplay/hwmgr/vega12_hwmgr.c
index 1937be1cf5b4..4bd573d815ff 100644
--- a/drivers/gpu/drm/amd/pm/powerplay/hwmgr/vega12_hwmgr.c
+++ b/drivers/gpu/drm/amd/pm/powerplay/hwmgr/vega12_hwmgr.c
@@ -1623,13 +1623,13 @@ static int vega12_notify_smc_display_config_after_ps_adjustment(
 
 	if (data->smu_features[GNLD_DPM_DCEFCLK].supported) {
 		clock_req.clock_type = amd_pp_dcef_clock;
-		clock_req.clock_freq_in_khz = min_clocks.dcefClock/10;
+		clock_req.clock_freq_in_khz = min_clocks.dcefClock / 10;
 		if (!vega12_display_clock_voltage_request(hwmgr, &clock_req)) {
 			if (data->smu_features[GNLD_DS_DCEFCLK].supported)
 				PP_ASSERT_WITH_CODE(
 					!smum_send_msg_to_smc_with_parameter(
 					hwmgr, PPSMC_MSG_SetMinDeepSleepDcefclk,
-					min_clocks.dcefClockInSR /100,
+					min_clocks.dcefClockInSR / 100,
 					NULL),
 					"Attempt to set divider for DCEFCLK Failed!",
 					return -1);
@@ -2354,8 +2354,8 @@ static int vega12_apply_clocks_adjust_rules(struct pp_hwmgr *hwmgr)
 	uint32_t i, latency;
 
 	disable_mclk_switching = ((1 < hwmgr->display_config->num_display) &&
-			          !hwmgr->display_config->multi_monitor_in_sync) ||
-			          vblank_too_short;
+				!hwmgr->display_config->multi_monitor_in_sync) ||
+				vblank_too_short;
 	latency = hwmgr->display_config->dce_tolerable_mclk_in_active_latency;
 
 	/* gfxclk */
@@ -2522,7 +2522,7 @@ static int vega12_set_uclk_to_highest_dpm_level(struct pp_hwmgr *hwmgr,
 		dpm_table->dpm_state.hard_min_level = dpm_table->dpm_levels[dpm_table->count - 1].value;
 		PP_ASSERT_WITH_CODE(!(ret = smum_send_msg_to_smc_with_parameter(hwmgr,
 				PPSMC_MSG_SetHardMinByFreq,
-				(PPCLK_UCLK << 16 ) | dpm_table->dpm_state.hard_min_level,
+				(PPCLK_UCLK << 16) | dpm_table->dpm_state.hard_min_level,
 				NULL)),
 				"[SetUclkToHightestDpmLevel] Set hard min uclk failed!",
 				return ret);
-- 
2.17.1



More information about the dri-devel mailing list