[PATCH v3 0/5] Add JDI LPM102A188A display panel support

[neil.armstrong at linaro.org]

On 16/08/2023 18:30, Thierry Reding wrote:
> On Mon, Aug 07, 2023 at 02:33:00PM +0100, Diogo Ivo wrote:
>> Hello,
>>
>> These patches add support for the JDI LPM102A188A display panel,
>> found in the Google Pixel C.
>>
>> Patch 1 adds the DT bindings for the panel.
>>
>> Patch 2 adds the panel driver, which is based on the downstream
>> kernel driver published by Google and developed by Sean Paul.
>>
>> Patches 3-5 add DT nodes for the regulator, backlight controller and
>> display panel.
>>
>> The first version of this patch series can be found at:
>> https://lore.kernel.org/all/20220929170502.1034040-1-diogo.ivo@tecnico.ulisboa.pt/
>>
>> The first submission of v2 can be found at:
>> https://lore.kernel.org/all/20221025153746.101278-1-diogo.ivo@tecnico.ulisboa.pt/
>>
>> Changes in v2:
>>   - Patch 1: remove touchscreen reset gpio property
>>   - Patch 2: clear register based on its value rather than a DT property
>>   - Patch 3: tune backlight delay values
>>   - Patch 4: add generic node names, remove underscores
>>
>> Changes in v3:
>>   - Patch 1: add Reviewed-by
>>   - Patch 2: fix error handling, remove enabled/prepared booleans, add
>>     dc/dc setting
>>   - Patches 3-5: Split previous patch 3 into three different patches,
>>     each adding a separate node
>>   - removed previous patch 2 pertaining to Tegra DSI reset as it was upstreamed
>>
>> Diogo Ivo (5):
>>    dt-bindings: display: Add bindings for JDI LPM102A188A
>>    drm/panel: Add driver for JDI LPM102A188A
>>    arm64: dts: smaug: Add DSI/CSI regulator
>>    arm64: dts: smaug: Add backlight node
>>    arm64: dts: smaug: Add display panel node
> 
> I've picked up patches 3-5 into the Tegra tree and I assume the other
> two will go in through drm-misc?

Sure, done !

> 
> Thierry