[PATCH 7/7] drm: adv7511: Add hpd_override_enable feature bit to struct adv7511_chip_info

Biju Das biju.das.jz at bp.renesas.com
Fri Aug 18 13:44:14 UTC 2023


Hi Adam,

> Subject: Re: [PATCH 7/7] drm: adv7511: Add hpd_override_enable feature bit
> to struct adv7511_chip_info
> 
> On Fri, Aug 18, 2023 at 8:35 AM Biju Das <biju.das.jz at bp.renesas.com>
> wrote:
> >
> > Hi Adam Ford,
> >
> > Thanks for the feedback.
> >
> > > Subject: Re: [PATCH 7/7] drm: adv7511: Add hpd_override_enable
> > > feature bit to struct adv7511_chip_info
> > >
> > > On Sun, Aug 13, 2023 at 1:06 PM Biju Das
> > > <biju.das.jz at bp.renesas.com>
> > > wrote:
> > > >
> > > > As per spec, it is allowed to pulse the HPD signal to indicate
> > > > that the EDID information has changed. Some monitors do this when
> > > > they wake up from standby or are enabled. When the HPD goes low
> > > > the adv7511 is reset and the outputs are disabled which might
> > > > cause the monitor to go to standby again. To avoid this we ignore
> > > > the HPD pin for the first few seconds after enabling the output.
> > > > On the other hand,
> > > > adv7535 require to enable HPD Override bit for proper HPD.
> > > >
> > > > Add hpd_override_enable feature bit to struct adv7511_chip_info to
> > > > handle this scenario.
> > > >
> > > > While at it, drop the enum adv7511_type as it is unused.
> > >
> > > It seems like dropping adv7511_type is unrelated to the rest of the
> > > patch, and I think it should be split from this into its own patch
> >
> > With this patch, there is no user for adv7511_type that is the reason
> > it is added here. I thought that is the common practice.
> >
> I wasn't sure.
> 
> > Please correct me if that is not the case.
> 
> I'll defer to the maintainers.  In general I like the series because it
> reduces the number of compare evaluations.  I'll try to run some tests on a
> board that I have with a adv7535 this weekend.

Thank you,
Biju

> >
> > Cheers,
> > Biju
> >
> > >
> > > adam
> > > >
> > > > Signed-off-by: Biju Das <biju.das.jz at bp.renesas.com>
> > > > ---
> > > >  drivers/gpu/drm/bridge/adv7511/adv7511.h     |  8 +-------
> > > >  drivers/gpu/drm/bridge/adv7511/adv7511_drv.c | 12 +++++-------
> > > >  2 files changed, 6 insertions(+), 14 deletions(-)
> > > >
> > > > diff --git a/drivers/gpu/drm/bridge/adv7511/adv7511.h
> > > > b/drivers/gpu/drm/bridge/adv7511/adv7511.h
> > > > index 627531f48f84..c523ac4c9bc8 100644
> > > > --- a/drivers/gpu/drm/bridge/adv7511/adv7511.h
> > > > +++ b/drivers/gpu/drm/bridge/adv7511/adv7511.h
> > > > @@ -325,22 +325,16 @@ struct adv7511_video_config {
> > > >         struct hdmi_avi_infoframe avi_infoframe;  };
> > > >
> > > > -enum adv7511_type {
> > > > -       ADV7511,
> > > > -       ADV7533,
> > > > -       ADV7535,
> > > > -};
> > > > -
> > > >  #define ADV7511_MAX_ADDRS 3
> > > >
> > > >  struct adv7511_chip_info {
> > > > -       enum adv7511_type type;
> > > >         unsigned long max_mode_clock;
> > > >         unsigned long max_lane_freq;
> > > >         const char * const *supply_names;
> > > >         unsigned int num_supplies;
> > > >         unsigned has_dsi:1;
> > > >         unsigned link_config:1;
> > > > +       unsigned hpd_override_enable:1;
> > > >  };
> > > >
> > > >  struct adv7511 {
> > > > diff --git a/drivers/gpu/drm/bridge/adv7511/adv7511_drv.c
> > > > b/drivers/gpu/drm/bridge/adv7511/adv7511_drv.c
> > > > index 6974c267b1d5..7b06a0a21685 100644
> > > > --- a/drivers/gpu/drm/bridge/adv7511/adv7511_drv.c
> > > > +++ b/drivers/gpu/drm/bridge/adv7511/adv7511_drv.c
> > > > @@ -354,7 +354,7 @@ static void __adv7511_power_on(struct adv7511
> > > *adv7511)
> > > >          * first few seconds after enabling the output. On the other
> hand
> > > >          * adv7535 require to enable HPD Override bit for proper HPD.
> > > >          */
> > > > -       if (adv7511->info->type == ADV7535)
> > > > +       if (adv7511->info->hpd_override_enable)
> > > >                 regmap_update_bits(adv7511->regmap,
> ADV7511_REG_POWER2,
> > > >                                    ADV7535_REG_POWER2_HPD_OVERRIDE,
> > > >
> > > > ADV7535_REG_POWER2_HPD_OVERRIDE); @@ -381,7 +381,7 @@ static void
> > > > adv7511_power_on(struct adv7511
> > > > *adv7511)  static void __adv7511_power_off(struct adv7511 *adv7511)
> {
> > > >         /* TODO: setup additional power down modes */
> > > > -       if (adv7511->info->type == ADV7535)
> > > > +       if (adv7511->info->hpd_override_enable)
> > > >                 regmap_update_bits(adv7511->regmap,
> ADV7511_REG_POWER2,
> > > >
> > > > ADV7535_REG_POWER2_HPD_OVERRIDE, 0);
> > > >
> > > > @@ -682,7 +682,7 @@ adv7511_detect(struct adv7511 *adv7511, struct
> > > drm_connector *connector)
> > > >                         status = connector_status_disconnected;
> > > >         } else {
> > > >                 /* Renable HPD sensing */
> > > > -               if (adv7511->info->type == ADV7535)
> > > > +               if (adv7511->info->hpd_override_enable)
> > > >                         regmap_update_bits(adv7511->regmap,
> > > ADV7511_REG_POWER2,
> > > >
> > > ADV7535_REG_POWER2_HPD_OVERRIDE,
> > > >
> > > > ADV7535_REG_POWER2_HPD_OVERRIDE); @@ -1360,14 +1360,12 @@ static
> > > > void adv7511_remove(struct i2c_client *i2c)  }
> > > >
> > > >  static const struct adv7511_chip_info adv7511_chip_info = {
> > > > -       .type = ADV7511,
> > > >         .supply_names = adv7511_supply_names,
> > > >         .num_supplies = ARRAY_SIZE(adv7511_supply_names),
> > > >         .link_config = 1
> > > >  };
> > > >
> > > >  static const struct adv7511_chip_info adv7533_chip_info = {
> > > > -       .type = ADV7533,
> > > >         .max_mode_clock = 80000,
> > > >         .max_lane_freq = 800000,
> > > >         .supply_names = adv7533_supply_names, @@ -1376,12 +1374,12
> > > > @@ static const struct adv7511_chip_info adv7533_chip_info = {  };
> > > >
> > > >  static const struct adv7511_chip_info adv7535_chip_info = {
> > > > -       .type = ADV7535,
> > > >         .max_mode_clock = 148500,
> > > >         .max_lane_freq = 891000,
> > > >         .supply_names = adv7533_supply_names,
> > > >         .num_supplies = ARRAY_SIZE(adv7533_supply_names),
> > > > -       .has_dsi = 1
> > > > +       .has_dsi = 1,
> > > > +       .hpd_override_enable = 1
> > > >  };
> > > >
> > > >  static const struct i2c_device_id adv7511_i2c_ids[] = {
> > > > --
> > > > 2.25.1
> > > >


More information about the dri-devel mailing list