[PATCH 5/5] drm/panel: st7703: Drive XBD599 panel at higher clock rate

[Jernej Škrabec]

Dne ponedeljek, 18. december 2023 ob 14:35:23 CET je Frank Oltmanns napisal(a):
> This panel is used in the pinephone that runs on a Allwinner A64 SOC.
> Acoording to it's datasheet, the SOC requires PLL-MIPI to run at more
> than 500 MHz.
> 
> Therefore, change [hv]sync_(start|end) so that we reach a clock rate
> that is high enough to drive PLL-MIPI within its limits.
> 
> Signed-off-by: Frank Oltmanns <frank at oltmanns.dev>

I'm not too sure about this patch. I see that PLL_MIPI doesn't have set
minimum frequency limit in clock driver. If you add it, clock framework
should find rate that is high enough and divisible with target rate.

Best regards,
Jernej  

> ---
>  drivers/gpu/drm/panel/panel-sitronix-st7703.c | 14 +++++++-------
>  1 file changed, 7 insertions(+), 7 deletions(-)
> 
> diff --git a/drivers/gpu/drm/panel/panel-sitronix-st7703.c b/drivers/gpu/drm/panel/panel-sitronix-st7703.c
> index b55bafd1a8be..6886fd7f765e 100644
> --- a/drivers/gpu/drm/panel/panel-sitronix-st7703.c
> +++ b/drivers/gpu/drm/panel/panel-sitronix-st7703.c
> @@ -320,14 +320,14 @@ static int xbd599_init_sequence(struct st7703 *ctx)
>  
>  static const struct drm_display_mode xbd599_mode = {
>  	.hdisplay    = 720,
> -	.hsync_start = 720 + 40,
> -	.hsync_end   = 720 + 40 + 40,
> -	.htotal	     = 720 + 40 + 40 + 40,
> +	.hsync_start = 720 + 65,
> +	.hsync_end   = 720 + 65 + 65,
> +	.htotal      = 720 + 65 + 65 + 65,
>  	.vdisplay    = 1440,
> -	.vsync_start = 1440 + 18,
> -	.vsync_end   = 1440 + 18 + 10,
> -	.vtotal	     = 1440 + 18 + 10 + 17,
> -	.clock	     = 69000,
> +	.vsync_start = 1440 + 30,
> +	.vsync_end   = 1440 + 30 + 22,
> +	.vtotal	     = 1440 + 30 + 22 + 29,
> +	.clock	     = (720 + 65 + 65 + 65) * (1440 + 30 + 22 + 29) * 60 / 1000,
>  	.flags	     = DRM_MODE_FLAG_NHSYNC | DRM_MODE_FLAG_NVSYNC,
>  	.width_mm    = 68,
>  	.height_mm   = 136,
> 
>