[PATCH 01/12] drm/bridge: lt9611: fix sleep mode setup

[Dmitry Baryshkov]

On atomic_post_disable the bridge goes to the low power state. However
the code disables too much of the chip, so the HPD event is not being
detected and delivered to the host. Reduce the power saving in order to
get the HPD event.

Fixes: 23278bf54afe ("drm/bridge: Introduce LT9611 DSI to HDMI bridge")
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
---
 drivers/gpu/drm/bridge/lontium-lt9611.c | 5 ++---
 1 file changed, 2 insertions(+), 3 deletions(-)

diff --git a/drivers/gpu/drm/bridge/lontium-lt9611.c b/drivers/gpu/drm/bridge/lontium-lt9611.c
index 7c0a99173b39..2714184cc53f 100644
--- a/drivers/gpu/drm/bridge/lontium-lt9611.c
+++ b/drivers/gpu/drm/bridge/lontium-lt9611.c
@@ -448,12 +448,11 @@ static void lt9611_sleep_setup(struct lt9611 *lt9611)
 		{ 0x8023, 0x01 },
 		{ 0x8157, 0x03 }, /* set addr pin as output */
 		{ 0x8149, 0x0b },
-		{ 0x8151, 0x30 }, /* disable IRQ */
+
 		{ 0x8102, 0x48 }, /* MIPI Rx power down */
 		{ 0x8123, 0x80 },
 		{ 0x8130, 0x00 },
-		{ 0x8100, 0x01 }, /* bandgap power down */
-		{ 0x8101, 0x00 }, /* system clk power down */
+		{ 0x8011, 0x0a },
 	};
 
 	regmap_multi_reg_write(lt9611->regmap,
-- 
2.39.0