[PATCH v3 18/19] drm/panel: sitronix-st7789v: Add EDT ET028013DMA panel support
Sebastian Reichel
sre at kernel.org
Fri Jul 14 01:37:55 UTC 2023
From: Miquel Raynal <miquel.raynal at bootlin.com>
This panel from Emerging Display Technologies Corporation features an
ST7789V2 LCD controller panel inside which is almost identical to what
the Sitronix panel driver supports.
In practice, the module physical size is specific, and experiments show
that the display will malfunction if any of the following situation
occurs:
* Pixel clock is above 3MHz
* Pixel clock is not inverted
I could not properly identify the reasons behind these failures, scope
captures show valid input signals.
Signed-off-by: Miquel Raynal <miquel.raynal at bootlin.com>
Acked-by: Maxime Ripard <mripard at kernel.org>
Reviewed-by: Sebastian Reichel <sre at kernel.org>
Signed-off-by: Sebastian Reichel <sre at kernel.org>
---
.../gpu/drm/panel/panel-sitronix-st7789v.c | 25 +++++++++++++++++++
1 file changed, 25 insertions(+)
diff --git a/drivers/gpu/drm/panel/panel-sitronix-st7789v.c b/drivers/gpu/drm/panel/panel-sitronix-st7789v.c
index 3d24690e891b..47387f127e05 100644
--- a/drivers/gpu/drm/panel/panel-sitronix-st7789v.c
+++ b/drivers/gpu/drm/panel/panel-sitronix-st7789v.c
@@ -187,6 +187,21 @@ static const struct drm_display_mode t28cp45tn89_mode = {
.flags = DRM_MODE_FLAG_PVSYNC | DRM_MODE_FLAG_NVSYNC,
};
+static const struct drm_display_mode et028013dma_mode = {
+ .clock = 3000,
+ .hdisplay = 240,
+ .hsync_start = 240 + 38,
+ .hsync_end = 240 + 38 + 10,
+ .htotal = 240 + 38 + 10 + 10,
+ .vdisplay = 320,
+ .vsync_start = 320 + 8,
+ .vsync_end = 320 + 8 + 4,
+ .vtotal = 320 + 8 + 4 + 4,
+ .width_mm = 43,
+ .height_mm = 58,
+ .flags = DRM_MODE_FLAG_PHSYNC | DRM_MODE_FLAG_PVSYNC,
+};
+
static const struct st7789_panel_info default_panel = {
.mode = &default_mode,
.invert_mode = true,
@@ -203,6 +218,14 @@ static const struct st7789_panel_info t28cp45tn89_panel = {
DRM_BUS_FLAG_PIXDATA_SAMPLE_POSEDGE,
};
+static const struct st7789_panel_info et028013dma_panel = {
+ .mode = &et028013dma_mode,
+ .invert_mode = true,
+ .bus_format = MEDIA_BUS_FMT_RGB666_1X18,
+ .bus_flags = DRM_BUS_FLAG_DE_HIGH |
+ DRM_BUS_FLAG_PIXDATA_SAMPLE_POSEDGE,
+};
+
static int st7789v_get_modes(struct drm_panel *panel,
struct drm_connector *connector)
{
@@ -474,6 +497,7 @@ static void st7789v_remove(struct spi_device *spi)
static const struct spi_device_id st7789v_spi_id[] = {
{ "st7789v", (unsigned long) &default_panel },
{ "t28cp45tn89-v17", (unsigned long) &t28cp45tn89_panel },
+ { "et028013dma", (unsigned long) &et028013dma_panel },
{ }
};
MODULE_DEVICE_TABLE(spi, st7789v_spi_id);
@@ -481,6 +505,7 @@ MODULE_DEVICE_TABLE(spi, st7789v_spi_id);
static const struct of_device_id st7789v_of_match[] = {
{ .compatible = "sitronix,st7789v", .data = &default_panel },
{ .compatible = "inanbo,t28cp45tn89-v17", .data = &t28cp45tn89_panel },
+ { .compatible = "edt,et028013dma", .data = &et028013dma_panel },
{ }
};
MODULE_DEVICE_TABLE(of, st7789v_of_match);
--
2.40.1
More information about the dri-devel
mailing list