[Freedreno] [RFC PATCH v2 04/13] drm/msm/dpu: remove unused fields from dpu_encoder_virt

[Abhinav Kumar]

On 3/20/2023 6:18 PM, Dmitry Baryshkov wrote:
> Remove historical fields intfs_swapped and topology fields from struct
> dpu_encoder_virt and also remove even more historical docs.
> 
> Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
> ---
>   drivers/gpu/drm/msm/disp/dpu1/dpu_encoder.c | 10 ----------
>   1 file changed, 10 deletions(-)
> 
> diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder.c
> index 28729c77364f..4ee708264f3b 100644
> --- a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder.c
> +++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder.c
> @@ -130,18 +130,12 @@ enum dpu_enc_rc_states {
>    *			pingpong blocks can be different than num_phys_encs.
>    * @hw_dsc:		Handle to the DSC blocks used for the display.
>    * @dsc_mask:		Bitmask of used DSC blocks.
> - * @intfs_swapped:	Whether or not the phys_enc interfaces have been swapped
> - *			for partial update right-only cases, such as pingpong
> - *			split where virtual pingpong does not generate IRQs
>    * @crtc:		Pointer to the currently assigned crtc. Normally you
>    *			would use crtc->state->encoder_mask to determine the
>    *			link between encoder/crtc. However in this case we need
>    *			to track crtc in the disable() hook which is called
>    *			_after_ encoder_mask is cleared.
>    * @connector:		If a mode is set, cached pointer to the active connector
> - * @crtc_kickoff_cb:		Callback into CRTC that will flush & start
> - *				all CTL paths
> - * @crtc_kickoff_cb_data:	Opaque user data given to crtc_kickoff_cb

no concerns with the above 3

>    * @enc_lock:			Lock around physical encoder
>    *				create/destroy/enable/disable
>    * @frame_busy_mask:		Bitmask tracking which phys_enc we are still
> @@ -160,7 +154,6 @@ enum dpu_enc_rc_states {
>    * @delayed_off_work:		delayed worker to schedule disabling of
>    *				clks and resources after IDLE_TIMEOUT time.
>    * @vsync_event_work:		worker to handle vsync event for autorefresh
> - * @topology:                   topology of the display

As we are still going to go ahead with encoder based allocation for now, 
we should keep this topology and start using it for DP DSC's 1:1:1 topology.

>    * @idle_timeout:		idle timeout duration in milliseconds
>    * @wide_bus_en:		wide bus is enabled on this interface
>    * @dsc:			drm_dsc_config pointer, for DSC-enabled encoders
> @@ -180,8 +173,6 @@ struct dpu_encoder_virt {
>   
>   	unsigned int dsc_mask;
>   
> -	bool intfs_swapped;
> -
>   	struct drm_crtc *crtc;
>   	struct drm_connector *connector;
>   
> @@ -201,7 +192,6 @@ struct dpu_encoder_virt {
>   	enum dpu_enc_rc_states rc_state;
>   	struct delayed_work delayed_off_work;
>   	struct kthread_work vsync_event_work;
> -	struct msm_display_topology topology;
>   
>   	u32 idle_timeout;
>