[PATCH 2/2] drm: bridge: tc358767: give VSDELAY some positive value

Lucas Stach l.stach at pengutronix.de
Wed Jun 7 12:53:23 UTC 2023


Am Freitag, dem 02.06.2023 um 23:34 +0200 schrieb Marek Vasut:
> On 6/2/23 21:15, Lucas Stach wrote:
> > From: David Jander <david at protonic.nl>
> > 
> > The documentation is not clear about how this delay works.
> > Empirical tests have shown that with a VSDELAY of 0, the first
> > scanline is not properly formatted in the output stream when
> > DSI->DP mode is used. The calculation spreadsheets from Toshiba
> > seem to always make this value equal to the HFP + 10 for DSI->DP
> > use-case. For DSI->DPI this value should be > 2 and for DPI->DP
> > it seems to always be 0x64.
> > 
> > Signed-off-by: David Jander <david at protonic.nl>
> > Signed-off-by: Lucas Stach <l.stach at pengutronix.de>
> > ---
> >   drivers/gpu/drm/bridge/tc358767.c | 2 +-
> >   1 file changed, 1 insertion(+), 1 deletion(-)
> > 
> > diff --git a/drivers/gpu/drm/bridge/tc358767.c b/drivers/gpu/drm/bridge/tc358767.c
> > index 46916ae30f8f..9f2c67b4a488 100644
> > --- a/drivers/gpu/drm/bridge/tc358767.c
> > +++ b/drivers/gpu/drm/bridge/tc358767.c
> > @@ -817,7 +817,7 @@ static int tc_set_common_video_mode(struct tc_data *tc,
> >   	 * sync signals
> >   	 */
> >   	ret = regmap_write(tc->regmap, VPCTRL0,
> > -			   FIELD_PREP(VSDELAY, 0) |
> > +			   FIELD_PREP(VSDELAY, right_margin + 10) |
> >   			   OPXLFMT_RGB888 | FRMSYNC_DISABLED | MSF_DISABLED);
> >   	if (ret)
> >   		return ret;
> 
> Aren't you running into a problem due to VS timing misconfiguration on 
> the scanout engine or DSI serializer side ? The VSDELAY seems to 
> increase the length of VSYNC active .
> 

No, as far as I understand the VSDELAY adds an offset between input an
output side of the video FIFO. It shouldn't increase the length of any
sync signal, but delays the read side of the FIFO, so the write (DSI)
side has some margin to put data into the FIFO before DP side starts to
assemble packets.

>  Which DSI bus mode do you use, sync events/pulses/burst ?

At the time when this patch was written it still was the SYNC_PULSE
mode.

Regards,
Lucas


More information about the dri-devel mailing list