[PATCH v1 2/8] dt-bindings: display: panel: mipi-dbi-spi: add spi-3wire property

[Rob Herring]

On Wed, Jun 07, 2023 at 09:59:47PM +0200, Noralf Trønnes wrote:
> 
> 
> On 6/7/23 13:55, Leonard Göhrs wrote:
> > Some MIPI DBI panels support a three wire mode (clock, chip select,
> > bidirectional data) that can be used to ask the panel if it is already set
> > up by e.g. the bootloader and can thus skip the initialization.
> > This enables a flicker-free boot.
> > 
> > Signed-off-by: Leonard Göhrs <l.goehrs at pengutronix.de>
> > ---
> >  .../devicetree/bindings/display/panel/panel-mipi-dbi-spi.yaml   | 2 ++
> >  1 file changed, 2 insertions(+)
> > 
> > diff --git a/Documentation/devicetree/bindings/display/panel/panel-mipi-dbi-spi.yaml b/Documentation/devicetree/bindings/display/panel/panel-mipi-dbi-spi.yaml
> > index c07da1a9e6288..2f0238b770eba 100644
> > --- a/Documentation/devicetree/bindings/display/panel/panel-mipi-dbi-spi.yaml
> > +++ b/Documentation/devicetree/bindings/display/panel/panel-mipi-dbi-spi.yaml
> > @@ -87,6 +87,8 @@ properties:
> >        Logic level supply for interface signals (Vddi).
> >        No need to set if this is the same as power-supply.
> >  
> > +  spi-3wire: true
> > +
> 
> I don't think this should be added here. spi-cpha and spi-cpol are also
> supported but they are not mentioned. Instead those are documented in
> bindings/spi/spi-controller.yaml. Why they're not documented in
> bindings/spi/spi-peripheral-props.yaml instead which this binding has a
> ref to, I have no idea.

spi-peripheral-props.yaml are properties of the controller in the 
peripheral nodes. spi-cpha and spi-cpol are properties of the device 
which are completely invalid on some devices. We can only check that by 
documenting where they are valid. I think spi-3wire is similar. There 
should be more explanation in the spi-peripheral-props.yaml commit 
history.

Rob