[PATCH 1/3] drm/msm/dpu: Add DPU_INTF_DATABUS_WIDEN feature flag for DPU >= 5.0

[Marijn Suijten]

On 2023-06-16 14:06:47, Abhinav Kumar wrote:
> On 6/14/2023 3:49 PM, Marijn Suijten wrote:
> > On 2023-06-14 14:23:38, Marijn Suijten wrote:
> > <snip>
> >> Tested this on SM8350 which actually has DSI 2.5, and it is also
> >> corrupted with this series so something else on this series might be
> >> broken.
> > 
> > Never mind, this was a bad conflict-resolve.  Jessica's original
> > BURST_MODE patch was RMW'ing MDP_CTRL2, but the upstreamed patch was
> > only writing, and the way I conflict-resolved that caused the write of
> > BURST_MODE to overwrite the RMW DATABUS_WIDEN.
> > 
> > If both are moved to dsi_ctrl_config(), we could do a read, add both
> > flags in conditionally, and write.
> > 
> 
> So just to confirm, there is no issue on your 8350 setup with widebus 
> enabled right?

After properly conflict-resolving both series so that they either both
RMW, or combine the two bit-sets (the same you just discussed _not_
doing on the DPU side for DATABUS_WIDEN|COMPRESSION...) before a single
write, it works fine!

- Marijn