[PATCH v14 06/14] drm/msm/disp/dpu: wait for extra vsync till timing engine status is disabled

Vinod Polimera quic_vpolimer at quicinc.com
Thu Mar 2 16:33:09 UTC 2023


There can be a race between timing gen disable and vblank irq. The
wait post timing gen disable may return early but intf disable sequence
might not be completed. Ensure that, intf status is disabled before
we retire the function.

Signed-off-by: Vinod Polimera <quic_vpolimer at quicinc.com>
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
---
 .../gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c    | 21 +++++++++++++++++++++
 1 file changed, 21 insertions(+)

diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c
index 48c4810..0396084 100644
--- a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c
+++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_vid.c
@@ -523,6 +523,7 @@ static void dpu_encoder_phys_vid_disable(struct dpu_encoder_phys *phys_enc)
 {
 	unsigned long lock_flags;
 	int ret;
+	struct intf_status intf_status = {0};
 
 	if (!phys_enc->parent || !phys_enc->parent->dev) {
 		DPU_ERROR("invalid encoder/device\n");
@@ -567,6 +568,26 @@ static void dpu_encoder_phys_vid_disable(struct dpu_encoder_phys *phys_enc)
 		}
 	}
 
+	if (phys_enc->hw_intf && phys_enc->hw_intf->ops.get_status)
+		phys_enc->hw_intf->ops.get_status(phys_enc->hw_intf, &intf_status);
+
+	/*
+	 * Wait for a vsync if timing en status is on after timing engine
+	 * is disabled.
+	 */
+	if (intf_status.is_en && dpu_encoder_phys_vid_is_master(phys_enc)) {
+		spin_lock_irqsave(phys_enc->enc_spinlock, lock_flags);
+		dpu_encoder_phys_inc_pending(phys_enc);
+		spin_unlock_irqrestore(phys_enc->enc_spinlock, lock_flags);
+		ret = dpu_encoder_phys_vid_wait_for_vblank(phys_enc);
+		if (ret) {
+			atomic_set(&phys_enc->pending_kickoff_cnt, 0);
+			DRM_ERROR("wait disable failed: id:%u intf:%d ret:%d\n",
+				  DRMID(phys_enc->parent),
+				  phys_enc->hw_intf->idx - INTF_0, ret);
+		}
+	}
+
 	phys_enc->enable_state = DPU_ENC_DISABLED;
 }
 
-- 
2.7.4



More information about the dri-devel mailing list