[PATCH v13 10/10] drm/bridge: it6505: Register Type C mode switches

[Andy Shevchenko]

On Fri, Mar 03, 2023 at 10:33:50PM +0800, Pin-yen Lin wrote:
> Register USB Type-C mode switches when the "mode-switch" property and
> relevant port are available in Device Tree. Configure the "lane_swap"
> state based on the entered alternate mode for a specific Type-C
> connector, which ends up updating the lane swap registers of the it6505
> chip.

...

> +	it6505->port_data = devm_kcalloc(dev, switch_desc->num_typec_switches,
> +					 sizeof(struct it6505_typec_port_data),
> +					 GFP_KERNEL);

> +

Same, no need for a blank line here.

> +	if (!it6505->port_data) {
> +		ret = -ENOMEM;
> +		goto unregister_mux;
> +	}

...

> +		it6505->port_data[i].lane_swap = (dp_lanes[0] / 2 == 1);

' % 2 == 0' ?

...

Wouldn't be better to have

	ret = PTR_ERR_OR_ZERO(extcon);

here and amend the following accordingly?

>  	if (PTR_ERR(extcon) == -EPROBE_DEFER)
>  		return -EPROBE_DEFER;
>  	if (IS_ERR(extcon)) {
> -		dev_err(dev, "can not get extcon device!");
> -		return PTR_ERR(extcon);
> +		if (PTR_ERR(extcon) != -ENODEV)
> +			dev_warn(dev, "Cannot get extcon device: %ld\n",
> +				 PTR_ERR(extcon));
> +		it6505->extcon = NULL;
> +	} else {
> +		it6505->extcon = extcon;
>  	}
>  
> -	it6505->extcon = extcon;
> +	init_completion(&it6505->mux_register);
> +	ret = it6505_register_typec_switches(dev, it6505);
> +	if (ret) {
> +		if (ret != -ENODEV)
> +			dev_warn(dev, "Didn't register Type-C switches, err: %d\n",
> +				 ret);
> +		if (!it6505->extcon) {
> +			dev_err(dev, "Both extcon and typec-switch are not registered.\n");
> +			return -EINVAL;
> +		}
> +	}


Perhaps

	if (ret != -ENODEV)
		dev_warn(dev, "Didn't register Type-C switches, err: %d\n", ret);

	if (ret && !it6505->extcon) {
		dev_err(dev, "Both extcon and typec-switch are not registered.\n");
		return ret;
	}

?

-- 
With Best Regards,
Andy Shevchenko