[PATCH V5 5/6] drm: bridge: samsung-dsim: Dynamically configure DPHY timing
Lucas Stach
l.stach at pengutronix.de
Fri May 12 19:37:11 UTC 2023
Hi Adam,
Am Samstag, dem 06.05.2023 um 14:24 -0500 schrieb Adam Ford:
> The DPHY timings are currently hard coded. Since the input
> clock can be variable, the phy timings need to be variable
> too. Add an additional variable to the driver data to enable
> this feature to prevent breaking boards that don't support it.
>
> The phy_mipi_dphy_get_default_config function configures the
> DPHY timings in pico-seconds, and a small macro converts those
> timings into clock cycles based on the pixel clock rate.
>
This week I finally had some time to take a deeper look at this series
and test it on some of my systems.
This patch causes issues when the burst clock rate is fixed by
supplying the DT entry. Instead of describing the issue below, I'm
attaching the patch that makes things work on my system.
I would appreciate if you could test this one on your side. Feel free
to squash it into yours if you find it working properly.
Also I would almost bet that dynamic_dphy is working on the Exynos
boards with that fix added. So if anyone with access to those boards
would like to give it a shot, we may be able to get rid of the
hardcoded PHY parameters altogether, which would be a nice cleanup.
Regards,
Lucas
> Signed-off-by: Adam Ford <aford173 at gmail.com>
> Tested-by: Chen-Yu Tsai <wenst at chromium.org>
> Tested-by: Frieder Schrempf <frieder.schrempf at kontron.de>
> Reviewed-by: Frieder Schrempf <frieder.schrempf at kontron.de>
> Tested-by: Michael Walle <michael at walle.cc>
> ---
> drivers/gpu/drm/bridge/samsung-dsim.c | 74 ++++++++++++++++++++++++---
> include/drm/bridge/samsung-dsim.h | 1 +
> 2 files changed, 68 insertions(+), 7 deletions(-)
>
> diff --git a/drivers/gpu/drm/bridge/samsung-dsim.c b/drivers/gpu/drm/bridge/samsung-dsim.c
> index 08266303c261..d19a5c87b749 100644
> --- a/drivers/gpu/drm/bridge/samsung-dsim.c
> +++ b/drivers/gpu/drm/bridge/samsung-dsim.c
> @@ -218,6 +218,8 @@
>
> #define OLD_SCLK_MIPI_CLK_NAME "pll_clk"
>
> +#define PS_TO_CYCLE(ps, hz) DIV64_U64_ROUND_CLOSEST(((ps) * (hz)), 1000000000000ULL)
> +
> static const char *const clk_names[5] = {
> "bus_clk",
> "sclk_mipi",
> @@ -487,6 +489,7 @@ static const struct samsung_dsim_driver_data imx8mm_dsi_driver_data = {
> .m_min = 64,
> .m_max = 1023,
> .min_freq = 1050,
> + .dynamic_dphy = 1,
> };
>
> static const struct samsung_dsim_driver_data *
> @@ -698,13 +701,50 @@ static void samsung_dsim_set_phy_ctrl(struct samsung_dsim *dsi)
> const struct samsung_dsim_driver_data *driver_data = dsi->driver_data;
> const unsigned int *reg_values = driver_data->reg_values;
> u32 reg;
> + struct drm_display_mode *m = &dsi->mode;
> + int bpp = mipi_dsi_pixel_format_to_bpp(dsi->format);
> + struct phy_configure_opts_mipi_dphy cfg;
> + int clk_prepare, lpx, clk_zero, clk_post, clk_trail;
> + int hs_exit, hs_prepare, hs_zero, hs_trail;
> + unsigned long long clock_in_hz = m->clock * 1000;
>
> if (driver_data->has_freqband)
> return;
>
> + /* The dynamic_phy has the ability to adjust PHY Timing settings */
> + if (driver_data->dynamic_dphy) {
> + phy_mipi_dphy_get_default_config(clock_in_hz, bpp, dsi->lanes, &cfg);
> +
> + /*
> + * TODO:
> + * The tech reference manual for i.MX8M Mini/Nano/Plus
> + * doesn't state what the definition of the PHYTIMING
> + * bits are beyond their address and bit position.
> + * After reviewing NXP's downstream code, it appears
> + * that the various PHYTIMING registers take the number
> + * of cycles and use various dividers on them. This
> + * calculation does not result in an exact match to the
> + * downstream code, but it is very close, and it appears
> + * to sync at a variety of resolutions. If someone
> + * can get a more accurate mathematical equation needed
> + * for these registers, this should be updated.
> + */
> +
> + lpx = PS_TO_CYCLE(cfg.lpx, clock_in_hz);
> + hs_exit = PS_TO_CYCLE(cfg.hs_exit, clock_in_hz);
> + clk_prepare = PS_TO_CYCLE(cfg.clk_prepare, clock_in_hz);
> + clk_zero = PS_TO_CYCLE(cfg.clk_zero, clock_in_hz);
> + clk_post = PS_TO_CYCLE(cfg.clk_post, clock_in_hz);
> + clk_trail = PS_TO_CYCLE(cfg.clk_trail, clock_in_hz);
> + hs_prepare = PS_TO_CYCLE(cfg.hs_prepare, clock_in_hz);
> + hs_zero = PS_TO_CYCLE(cfg.hs_zero, clock_in_hz);
> + hs_trail = PS_TO_CYCLE(cfg.hs_trail, clock_in_hz);
> + }
> +
> /* B D-PHY: D-PHY Master & Slave Analog Block control */
> reg = reg_values[PHYCTRL_ULPS_EXIT] | reg_values[PHYCTRL_VREG_LP] |
> reg_values[PHYCTRL_SLEW_UP];
> +
> samsung_dsim_write(dsi, DSIM_PHYCTRL_REG, reg);
>
> /*
> @@ -712,7 +752,11 @@ static void samsung_dsim_set_phy_ctrl(struct samsung_dsim *dsi)
> * T HS-EXIT: Time that the transmitter drives LP-11 following a HS
> * burst
> */
> - reg = reg_values[PHYTIMING_LPX] | reg_values[PHYTIMING_HS_EXIT];
> + if (driver_data->dynamic_dphy)
> + reg = DSIM_PHYTIMING_LPX(lpx) | DSIM_PHYTIMING_HS_EXIT(hs_exit);
> + else
> + reg = reg_values[PHYTIMING_LPX] | reg_values[PHYTIMING_HS_EXIT];
> +
> samsung_dsim_write(dsi, DSIM_PHYTIMING_REG, reg);
>
> /*
> @@ -728,10 +772,17 @@ static void samsung_dsim_set_phy_ctrl(struct samsung_dsim *dsi)
> * T CLK-TRAIL: Time that the transmitter drives the HS-0 state after
> * the last payload clock bit of a HS transmission burst
> */
> - reg = reg_values[PHYTIMING_CLK_PREPARE] |
> - reg_values[PHYTIMING_CLK_ZERO] |
> - reg_values[PHYTIMING_CLK_POST] |
> - reg_values[PHYTIMING_CLK_TRAIL];
> + if (driver_data->dynamic_dphy) {
> + reg = DSIM_PHYTIMING1_CLK_PREPARE(clk_prepare) |
> + DSIM_PHYTIMING1_CLK_ZERO(clk_zero) |
> + DSIM_PHYTIMING1_CLK_POST(clk_post) |
> + DSIM_PHYTIMING1_CLK_TRAIL(clk_trail);
> + } else {
> + reg = reg_values[PHYTIMING_CLK_PREPARE] |
> + reg_values[PHYTIMING_CLK_ZERO] |
> + reg_values[PHYTIMING_CLK_POST] |
> + reg_values[PHYTIMING_CLK_TRAIL];
> + }
>
> samsung_dsim_write(dsi, DSIM_PHYTIMING1_REG, reg);
>
> @@ -744,8 +795,17 @@ static void samsung_dsim_set_phy_ctrl(struct samsung_dsim *dsi)
> * T HS-TRAIL: Time that the transmitter drives the flipped differential
> * state after last payload data bit of a HS transmission burst
> */
> - reg = reg_values[PHYTIMING_HS_PREPARE] | reg_values[PHYTIMING_HS_ZERO] |
> - reg_values[PHYTIMING_HS_TRAIL];
> +
> + if (driver_data->dynamic_dphy) {
> + reg = DSIM_PHYTIMING2_HS_PREPARE(hs_prepare) |
> + DSIM_PHYTIMING2_HS_ZERO(hs_zero) |
> + DSIM_PHYTIMING2_HS_TRAIL(hs_trail);
> + } else {
> + reg = reg_values[PHYTIMING_HS_PREPARE] |
> + reg_values[PHYTIMING_HS_ZERO] |
> + reg_values[PHYTIMING_HS_TRAIL];
> + }
> +
> samsung_dsim_write(dsi, DSIM_PHYTIMING2_REG, reg);
> }
>
> diff --git a/include/drm/bridge/samsung-dsim.h b/include/drm/bridge/samsung-dsim.h
> index a1a5b2b89a7a..76ea8a1720cc 100644
> --- a/include/drm/bridge/samsung-dsim.h
> +++ b/include/drm/bridge/samsung-dsim.h
> @@ -62,6 +62,7 @@ struct samsung_dsim_driver_data {
> const unsigned int *reg_values;
> u16 m_min;
> u16 m_max;
> + bool dynamic_dphy;
> };
>
> struct samsung_dsim_host_ops {
-------------- next part --------------
A non-text attachment was scrubbed...
Name: 0001-drm-bridge-samsung-dsim-use-HS-clock-to-calculate-PH.patch
Type: text/x-patch
Size: 3157 bytes
Desc: not available
URL: <https://lists.freedesktop.org/archives/dri-devel/attachments/20230512/c36a2f05/attachment-0001.bin>
More information about the dri-devel
mailing list