[PATCH 4/7] drm/msm/dpu: Allow configuring multiple active DSC blocks

Dmitry Baryshkov dmitry.baryshkov at linaro.org
Wed Apr 17 11:59:34 UTC 2024


On Wed, 17 Apr 2024 at 02:57, Marijn Suijten
<marijn.suijten at somainline.org> wrote:
>
> Just like the active interface and writeback block in ctl_intf_cfg_v1(),
> and later the rest of the blocks in followup active-CTL fixes or
> reworks, multiple calls to this function should enable additional DSC
> blocks instead of overwriting the blocks that are enabled.
>
> This pattern is observed in an active-CTL scenario since DPU 5.0.0 where
> for example bonded-DSI uses a single CTL to drive multiple INTFs, and
> each encoder calls this function individually with the INTF (hence the
> pre-existing update instead of overwrite of this bitmask) and DSC blocks
> it wishes to be enabled, and expects them to be OR'd into the bitmask.
>
> The reverse already exists in reset_intf_cfg_v1() where only specified
> DSC blocks are removed out of the CTL_DSC_ACTIVE bitmask (same for all
> other blocks and ACTIVE bitmasks), leaving the rest enabled.
>
> Fixes: 77f6da90487c ("drm/msm/disp/dpu1: Add DSC support in hw_ctl")
> Signed-off-by: Marijn Suijten <marijn.suijten at somainline.org>
> ---
>  drivers/gpu/drm/msm/disp/dpu1/dpu_hw_ctl.c | 9 ++++++---
>  1 file changed, 6 insertions(+), 3 deletions(-)


Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>

-- 
With best wishes
Dmitry


More information about the dri-devel mailing list