[PATCH v2 2/2] drm/msm/dpu: don't play tricks with debug macros

[Abhinav Kumar]

On 8/2/2024 12:47 PM, Dmitry Baryshkov wrote:
> DPU debugging macros need to be converted to a proper drm_debug_*
> macros, however this is a going an intrusive patch, not suitable for a
> fix. Wire DPU_DEBUG and DPU_DEBUG_DRIVER to always use DRM_DEBUG_DRIVER
> to make sure that DPU debugging messages always end up in the drm debug
> messages and are controlled via the usual drm.debug mask.
> 
> I don't think that it is a good idea for a generic DPU_DEBUG macro to be
> tied to DRM_UT_KMS. It is used to report a debug message from driver, so by
> default it should go to the DRM_UT_DRIVER channel. While refactoring
> debug macros later on we might end up with particular messages going to
> ATOMIC or KMS, but DRIVER should be the default.
> 
> Fixes: 25fdd5933e4c ("drm/msm: Add SDM845 DPU support")
> Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
> ---
>   drivers/gpu/drm/msm/disp/dpu1/dpu_kms.h | 14 ++------------
>   1 file changed, 2 insertions(+), 12 deletions(-)
> 

Reviewed-by: Abhinav Kumar <quic_abhinavk at quicinc.com>