[PATCH v2 3/5] drm/rockchip: vop2: Improve display modes handling on RK3588 HDMI0

[Cristian Ciocaltea]

The RK3588 specific implementation is currently quite limited in terms
of handling the full range of display modes supported by the connected
screens, e.g. 2560x1440 at 75Hz, 2048x1152 at 60Hz, 1024x768 at 60Hz are just a
few of them.

Additionally, it doesn't cope well with non-integer refresh rates like
59.94, 29.97, 23.98, etc.

Make use of HDMI0 PHY PLL as a more accurate DCLK source to handle
all display modes up to 4K at 60Hz.

Tested-by: FUKAUMI Naoki <naoki at radxa.com>
Signed-off-by: Cristian Ciocaltea <cristian.ciocaltea at collabora.com>
---
 drivers/gpu/drm/rockchip/rockchip_drm_vop2.c | 34 ++++++++++++++++++++++++++++
 1 file changed, 34 insertions(+)

diff --git a/drivers/gpu/drm/rockchip/rockchip_drm_vop2.c b/drivers/gpu/drm/rockchip/rockchip_drm_vop2.c
index 8b2f53ffefdbf1cc8737b3a86e630a03a7fd9348..393fe6aa170aaee9663c4a6d98c1cd6a5ef79392 100644
--- a/drivers/gpu/drm/rockchip/rockchip_drm_vop2.c
+++ b/drivers/gpu/drm/rockchip/rockchip_drm_vop2.c
@@ -158,6 +158,7 @@ struct vop2_video_port {
 	struct drm_crtc crtc;
 	struct vop2 *vop2;
 	struct clk *dclk;
+	struct clk *dclk_src;
 	unsigned int id;
 	const struct vop2_video_port_data *data;
 
@@ -212,6 +213,7 @@ struct vop2 {
 	struct clk *hclk;
 	struct clk *aclk;
 	struct clk *pclk;
+	struct clk *pll_hdmiphy0;
 
 	/* optional internal rgb encoder */
 	struct rockchip_rgb *rgb;
@@ -220,6 +222,8 @@ struct vop2 {
 	struct vop2_win win[];
 };
 
+#define VOP2_MAX_DCLK_RATE		600000 /* kHz */
+
 #define vop2_output_if_is_hdmi(x)	((x) == ROCKCHIP_VOP2_EP_HDMI0 || \
 					 (x) == ROCKCHIP_VOP2_EP_HDMI1)
 
@@ -1033,6 +1037,9 @@ static void vop2_crtc_atomic_disable(struct drm_crtc *crtc,
 
 	vop2_crtc_disable_irq(vp, VP_INT_DSP_HOLD_VALID);
 
+	if (vp->dclk_src)
+		clk_set_parent(vp->dclk, vp->dclk_src);
+
 	clk_disable_unprepare(vp->dclk);
 
 	vop2->enable_count--;
@@ -2049,6 +2056,27 @@ static void vop2_crtc_atomic_enable(struct drm_crtc *crtc,
 
 	vop2_vp_write(vp, RK3568_VP_MIPI_CTRL, 0);
 
+	/*
+	 * Switch to HDMI PHY PLL as DCLK source for display modes up
+	 * to 4K at 60Hz, if available, otherwise keep using the system CRU.
+	 */
+	if (vop2->pll_hdmiphy0 && mode->crtc_clock <= VOP2_MAX_DCLK_RATE) {
+		drm_for_each_encoder_mask(encoder, crtc->dev, crtc_state->encoder_mask) {
+			struct rockchip_encoder *rkencoder = to_rockchip_encoder(encoder);
+
+			if (rkencoder->crtc_endpoint_id == ROCKCHIP_VOP2_EP_HDMI0) {
+				if (!vp->dclk_src)
+					vp->dclk_src = clk_get_parent(vp->dclk);
+
+				ret = clk_set_parent(vp->dclk, vop2->pll_hdmiphy0);
+				if (ret < 0)
+					drm_warn(vop2->drm,
+						 "Could not switch to HDMI0 PHY PLL: %d\n", ret);
+				break;
+			}
+		}
+	}
+
 	clk_set_rate(vp->dclk, clock);
 
 	vop2_post_config(crtc);
@@ -3167,6 +3195,12 @@ static int vop2_bind(struct device *dev, struct device *master, void *data)
 		return PTR_ERR(vop2->pclk);
 	}
 
+	vop2->pll_hdmiphy0 = devm_clk_get_optional(vop2->dev, "pll_hdmiphy0");
+	if (IS_ERR(vop2->pll_hdmiphy0)) {
+		drm_err(vop2->drm, "failed to get pll_hdmiphy0\n");
+		return PTR_ERR(vop2->pll_hdmiphy0);
+	}
+
 	vop2->irq = platform_get_irq(pdev, 0);
 	if (vop2->irq < 0) {
 		drm_err(vop2->drm, "cannot find irq for vop2\n");

-- 
2.47.0