[PATCH 1/4] drm/hyperv: Remove firmware framebuffers with aperture helper

[Thomas Zimmermann]

Replace use of screen_info state with the correct interface from
the aperture helpers. The state is only for architecture and firmware
code. It is not guaranteed to contain valid data. Drivers are thus
not allowed to use it.

For removing conflicting firmware framebuffers, there are aperture
helpers. Hence replace screen_info with the correct function that will
remove conflicting framebuffers for the hyperv-drm driver. Also
move the call to the correct place within the driver.

Signed-off-by: Thomas Zimmermann <tzimmermann at suse.de>
---
 drivers/gpu/drm/hyperv/hyperv_drm_drv.c | 8 ++------
 1 file changed, 2 insertions(+), 6 deletions(-)

diff --git a/drivers/gpu/drm/hyperv/hyperv_drm_drv.c b/drivers/gpu/drm/hyperv/hyperv_drm_drv.c
index d511d17c5bdf..cff85086f2d6 100644
--- a/drivers/gpu/drm/hyperv/hyperv_drm_drv.c
+++ b/drivers/gpu/drm/hyperv/hyperv_drm_drv.c
@@ -7,7 +7,6 @@
 #include <linux/hyperv.h>
 #include <linux/module.h>
 #include <linux/pci.h>
-#include <linux/screen_info.h>
 
 #include <drm/drm_aperture.h>
 #include <drm/drm_atomic_helper.h>
@@ -73,11 +72,6 @@ static int hyperv_setup_vram(struct hyperv_drm_device *hv,
 	struct drm_device *dev = &hv->dev;
 	int ret;
 
-	if (IS_ENABLED(CONFIG_SYSFB))
-		drm_aperture_remove_conflicting_framebuffers(screen_info.lfb_base,
-							     screen_info.lfb_size,
-							     &hyperv_driver);
-
 	hv->fb_size = (unsigned long)hv->mmio_megabytes * 1024 * 1024;
 
 	ret = vmbus_allocate_mmio(&hv->mem, hdev, 0, -1, hv->fb_size, 0x100000,
@@ -130,6 +124,8 @@ static int hyperv_vmbus_probe(struct hv_device *hdev,
 		goto err_hv_set_drv_data;
 	}
 
+	drm_aperture_remove_framebuffers(&hyperv_driver);
+
 	ret = hyperv_setup_vram(hv, hdev);
 	if (ret)
 		goto err_vmbus_close;
-- 
2.43.0