[PATCH v2 3/4] arm64: dts: qcom: x1e80100-crd: Fix backlight

[Johan Hovold]

On Mon, Jul 15, 2024 at 02:15:39PM +0200, Stephan Gerhold wrote:
> The backlight does not work correctly with the current display panel
> configuration: It works after boot, but once the display gets disabled it
> is not possible to get it back on. It turns out that the ATNA45AF01 panel
> needs exactly the same non-standard power sequence as implemented by the
> panel-samsung-atna33xc20 driver for sc7180-trogdor-homestar.
> 
> Switch the panel in the DT to the new compatible and make two more changes
> to make it work correctly:
> 
>  1. Add the missing GPIO for the panel EL_ON3 line (EDP_BL_EN on CRD and
>     enable-gpios in the DT).
>  2. Drop the regulator-always-on for the panel regulator. The panel does
>     not seem to power off properly if the regulator stays on.
> 
> Fixes: d7e03cce0400 ("arm64: dts: qcom: x1e80100-crd: Enable more support")
> Reviewed-by: Konrad Dybcio <konrad.dybcio at linaro.org>
> Signed-off-by: Stephan Gerhold <stephan.gerhold at linaro.org>
> ---
> This can be applied as fix for 6.11 since the driver works as-is with the
> fallback compatible. If so, the defconfig patch should ideally also go
> there to ensure people actually have the driver enabled.

Verified that I can change the brightness setting and that the backlight
comes on again after being turned off (e.g. at suspend):

Reviewed-by: Johan Hovold <johan+linaro at kernel.org>
Tested-by: Johan Hovold <johan+linaro at kernel.org>