[PATCH V2] drm/bridge: adv7511: Fix Intermittent EDID failures

[Dmitry Baryshkov]

On Sat, Jun 01, 2024 at 08:24:59AM GMT, Adam Ford wrote:
> In the process of adding support for shared IRQ pins, a scenario
> was accidentally created where adv7511_irq_process returned
> prematurely causing the EDID to fail randomly.
> 
> Since the interrupt handler is broken up into two main helper functions,
> update both of them to treat the helper functions as IRQ handlers. These
> IRQ routines process their respective tasks as before, but if they
> determine that actual work was done, mark the respective IRQ status
> accordingly, and delay the check until everything has been processed.
> 
> This should guarantee the helper functions don't return prematurely
> while still returning proper values of either IRQ_HANDLED or IRQ_NONE.
> 
> Reported-by: Liu Ying <victor.liu at nxp.com>
> Fixes: f3d9683346d6 ("drm/bridge: adv7511: Allow IRQ to share GPIO pins")
> Signed-off-by: Adam Ford <aford173 at gmail.com>
> Tested-by: Liu Ying <victor.liu at nxp.com> # i.MX8MP EVK ADV7535 EDID retrieval w/o IRQ
> ---
> V2:  Fix uninitialized cec_status
>      Cut back a little on error handling to return either IRQ_NONE or
>      IRQ_HANDLED.
> 
> diff --git a/drivers/gpu/drm/bridge/adv7511/adv7511.h b/drivers/gpu/drm/bridge/adv7511/adv7511.h
> index ea271f62b214..ec0b7f3d889c 100644
> --- a/drivers/gpu/drm/bridge/adv7511/adv7511.h
> +++ b/drivers/gpu/drm/bridge/adv7511/adv7511.h
> @@ -401,7 +401,7 @@ struct adv7511 {
>  
>  #ifdef CONFIG_DRM_I2C_ADV7511_CEC
>  int adv7511_cec_init(struct device *dev, struct adv7511 *adv7511);
> -void adv7511_cec_irq_process(struct adv7511 *adv7511, unsigned int irq1);
> +int adv7511_cec_irq_process(struct adv7511 *adv7511, unsigned int irq1);
>  #else
>  static inline int adv7511_cec_init(struct device *dev, struct adv7511 *adv7511)
>  {
> diff --git a/drivers/gpu/drm/bridge/adv7511/adv7511_cec.c b/drivers/gpu/drm/bridge/adv7511/adv7511_cec.c
> index 44451a9658a3..651fb1dde780 100644
> --- a/drivers/gpu/drm/bridge/adv7511/adv7511_cec.c
> +++ b/drivers/gpu/drm/bridge/adv7511/adv7511_cec.c
> @@ -119,7 +119,7 @@ static void adv7511_cec_rx(struct adv7511 *adv7511, int rx_buf)
>  	cec_received_msg(adv7511->cec_adap, &msg);
>  }
>  
> -void adv7511_cec_irq_process(struct adv7511 *adv7511, unsigned int irq1)
> +int adv7511_cec_irq_process(struct adv7511 *adv7511, unsigned int irq1)
>  {
>  	unsigned int offset = adv7511->info->reg_cec_offset;
>  	const u32 irq_tx_mask = ADV7511_INT1_CEC_TX_READY |
> @@ -130,17 +130,21 @@ void adv7511_cec_irq_process(struct adv7511 *adv7511, unsigned int irq1)
>  				ADV7511_INT1_CEC_RX_READY3;
>  	unsigned int rx_status;
>  	int rx_order[3] = { -1, -1, -1 };
> -	int i;
> +	int i, ret = 0;
> +	int irq_status = IRQ_NONE;
>  
> -	if (irq1 & irq_tx_mask)
> +	if (irq1 & irq_tx_mask) {
>  		adv_cec_tx_raw_status(adv7511, irq1);
> +		irq_status = IRQ_HANDLED;
> +	}
>  
>  	if (!(irq1 & irq_rx_mask))
> -		return;
> +		return irq_status;
>  
> -	if (regmap_read(adv7511->regmap_cec,
> -			ADV7511_REG_CEC_RX_STATUS + offset, &rx_status))
> -		return;
> +	ret = regmap_read(adv7511->regmap_cec,
> +			ADV7511_REG_CEC_RX_STATUS + offset, &rx_status);

There is no need for the ret variable, regmap_read can return either 0
or a negative error code.

With that fixed:


Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>


> +	if (ret < 0)
> +		return irq_status;
>  
>  	/*
>  	 * ADV7511_REG_CEC_RX_STATUS[5:0] contains the reception order of RX


-- 
With best wishes
Dmitry