[PATCH v15 00/29] drm/connector: Create HDMI Connector infrastructure
Maxime Ripard
mripard at kernel.org
Mon May 27 13:57:49 UTC 2024
Hi,
Here's a series that creates some extra infrastructure specifically
targeted at HDMI controllers.
The idea behind this series came from a recent discussion on IRC during
which we discussed infoframes generation of i915 vs everything else.
Infoframes generation code still requires some decent boilerplate, with
each driver doing some variation of it.
In parallel, while working on vc4, we ended up converting a lot of i915
logic (mostly around format / bpc selection, and scrambler setup) to
apply on top of a driver that relies only on helpers.
While currently sitting in the vc4 driver, none of that logic actually
relies on any driver or hardware-specific behaviour.
The only missing piece to make it shareable are a bunch of extra
variables stored in a state (current bpc, format, RGB range selection,
etc.).
The initial implementation was relying on some generic subclass of
drm_connector to address HDMI connectors, with a bunch of helpers that
will take care of all the "HDMI Spec" related code. Scrambler setup is
missing at the moment but can easily be plugged in.
The feedback was that creating a connector subclass like was done for
writeback would prevent the adoption of those helpers since it couldn't
be used in all situations (like when the connector driver can implement
multiple output) and required more churn to cast between the
drm_connector and its subclass. The decision was thus to provide a set
of helper and to store the required variables in drm_connector and
drm_connector_state. This what has been implemented now.
Hans Verkuil also expressed interest in implementing a mechanism in v4l2
to retrieve infoframes from HDMI receiver and implementing a tool to
decode (and eventually check) infoframes. His current work on
edid-decode to enable that based on that series can be found here:
https://git.linuxtv.org/hverkuil/edid-decode.git/log/?h=hverkuil
And some more context here:
https://lore.kernel.org/dri-devel/50db7366-cd3d-4675-aaad-b857202234de@xs4all.nl/
This series thus leverages the infoframe generation code to expose it
through debugfs.
I also used the occasion to unit-test everything but the infoframe
generation, which can come later once I get a proper understanding of
what the infoframe are supposed to look like. This required to add some
extra kunit helpers and infrastructure to have multiple EDIDs and allow
each test to run with a particular set of capabilities.
This entire series has been tested on a Pi4, passes all its unittests
(125 new tests), and has only been build-tested for sunxi and rockchip.
Let me know what you think,
Maxime
Signed-off-by: Maxime Ripard <mripard at kernel.org>
---
Changes in v15:
- Fix YUV422 bpc check
- Mention explicitly (and in the logs) that YUV420 isn't supported for
now
- Fix warning when running the bpc test
- Change the order of the drm_mode_obj_find_prop_id export patch
- Fix some sun4i changes having made their way into the rockchip patch
- Drop spurious Broadcast RGB documentation
- Link to v14: https://lore.kernel.org/r/20240521-kms-hdmi-connector-state-v14-0-51950db4fedb@kernel.org
Changes in v14:
- Warn instead of rejecting the configuration if RGB is missing due to
some bad or faulty EDID
- Link to v13: https://lore.kernel.org/r/20240507-kms-hdmi-connector-state-v13-0-8fafc5efe8be@kernel.org
Changes in v13:
- Adapt to latest Kconfig helper changes
- Fixes for sun4i and rockchip
- Rebase on current drm-misc-next
- Link to v12: https://lore.kernel.org/r/20240423-kms-hdmi-connector-state-v12-0-3338e4c0b189@kernel.org
Changes in v12:
- Rebase on current drm-misc-next
- Remove VIC check in clock rate computation function
- Invert RGB range logic to signal limited range instead of full like
before
- Link to v11: https://lore.kernel.org/r/20240326-kms-hdmi-connector-state-v11-0-c5680ffcf261@kernel.org
Changes in v11:
- Turn the HDMI state helpers into a separate C file under
drivers/gpu/drm/display
- Rework the Kconfig options too to prevent configuration breakages.
- Link to v10: https://lore.kernel.org/r/20240321-kms-hdmi-connector-state-v10-0-e6c178361898@kernel.org
Changes in v10:
- Drop the YUV422 fallback, and adjust the tests accordingly
- Fix HDMI infoframe handling
- Remove the infoframe copy in drm_connector
- Add a TODO that drm_hdmi_avi_infoframe_quant_range() only works for
RGB
- Add a TODO for the YUV420 selection
- Fix a few bugs in vc4
- Change the logging from driver to KMS for the helpers
- Drop UPDATE_INFOFRAME macro
- Add infoframe code logging
- Document the selection of 8bpc for VIC1
- Rename state to conn_state where relevant
- Link to v9: https://lore.kernel.org/r/20240311-kms-hdmi-connector-state-v9-0-d45890323344@kernel.org
Changes in v9:
- Generate every infoframe but the HDMI vendor one if has_hdmi_infoframe
isn't set
- Fix typos in the doc
- Removed undef for inexisting macro
- Improve the Broadcast RGB sanitation test
- Make EDID bytes array const
- Link to v8: https://lore.kernel.org/r/20240307-kms-hdmi-connector-state-v8-0-ef6a6f31964b@kernel.org
Changes in v8:
- Drop applied patches
- Drop the YUV limited range mention in the Broadcast RGB documentation
- Rephrase the vc4_dummy_plane removal commit log
- Move infroframe mutex initialisation to the main drm_connector_init
function to make sure it's always initialised
- Link to v7: https://lore.kernel.org/r/20240222-kms-hdmi-connector-state-v7-0-8f4af575fce2@kernel.org
Changes in v7:
- Rebased on top of current next
- Only consider the Broadcast RGB property if the output format is RGB,
and use a limited range otherwise
- Document the fact that Broadcast RGB only applies if the output format
is RGB
- Add some test to make sure we always get a limited range if we have a
YCbCr output format.
- Link to v6: https://lore.kernel.org/r/20240212-kms-hdmi-connector-state-v6-0-f4bcdc979e6f@kernel.org
Changes in v6:
- Rebased on top of current next
- Split the tests into separate patches
- Improve the Broadcast RGB documentation
- Link to v5: https://lore.kernel.org/r/20231207-kms-hdmi-connector-state-v5-0-6538e19d634d@kernel.org
Changes in v5:
- Dropped the connector init arg checking patch, and the related kunit
tests
- Dropped HDMI Vendor infoframes in rockchip inno_hdmi
- Fixed the build warnings
- Link to v4: https://lore.kernel.org/r/20231128-kms-hdmi-connector-state-v4-0-c7602158306e@kernel.org
Changes in v4:
- Create unit tests for everything but infoframes
- Fix a number of bugs identified by the unit tests
- Rename DRM (Dynamic Range and Mastering) infoframe file to HDR_DRM
- Drop RFC status
- Link to v3: https://lore.kernel.org/r/20231031-kms-hdmi-connector-state-v3-0-328b0fae43a7@kernel.org
Changes in v3:
- Made sure the series work on the RaspberryPi4
- Handle YUV420 in the char clock rate computation
- Use the maximum bpc value the connector allows at reset
- Expose the RGB Limited vs Full Range value in the connector state
instead of through a helper
- Fix Broadcast RGB documentation
- Add more debug logging
- Small fixes here and there
- Link to v2: https://lore.kernel.org/r/20230920-kms-hdmi-connector-state-v2-0-17932daddd7d@kernel.org
Changes in v2:
- Change from a subclass to a set of helpers for drm_connector and
drm_connector state
- Don't assume that all drivers support RGB, YUV420 and YUV422 but make
them provide a bitfield instead.
- Don't assume that all drivers support the Broadcast RGB property but
make them call the registration helper.
- Document the Broacast RGB property
- Convert the inno_hdmi and sun4i_hdmi driver.
- Link to v1: https://lore.kernel.org/r/20230814-kms-hdmi-connector-state-v1-0-048054df3654@kernel.org
---
Maxime Ripard (29):
drm/connector: Introduce an HDMI connector initialization function
drm/tests: connector: Add tests for drmm_connector_hdmi_init
drm/connector: hdmi: Create an HDMI sub-state
drm/connector: hdmi: Add output BPC to the connector state
drm/mode_object: Export drm_mode_obj_find_prop_id for tests
drm/tests: Add output bpc tests
drm/connector: hdmi: Add support for output format
drm/tests: Add output formats tests
drm/display: hdmi: Add HDMI compute clock helper
drm/tests: Add HDMI TDMS character rate tests
drm/connector: hdmi: Calculate TMDS character rate
drm/tests: Add TDMS character rate connector state tests
drm/connector: hdmi: Add custom hook to filter TMDS character rate
drm/tests: Add HDMI connector rate filter hook tests
drm/connector: hdmi: Compute bpc and format automatically
drm/tests: Add HDMI connector bpc and format tests
drm/doc: Remove unused Broadcast RGB Property
drm/connector: hdmi: Add Broadcast RGB property
drm/tests: Add tests for Broadcast RGB property
drm/connector: hdmi: Add RGB Quantization Range to the connector state
drm/tests: Add RGB Quantization tests
drm/connector: hdmi: Add Infoframes generation
drm/tests: Add infoframes test
drm/connector: hdmi: Create Infoframe DebugFS entries
drm/vc4: hdmi: Switch to HDMI connector
drm/vc4: tests: Remove vc4_dummy_plane structure
drm/vc4: tests: Convert to plane creation helper
drm/rockchip: inno_hdmi: Switch to HDMI connector
drm/sun4i: hdmi: Switch to HDMI connector
Documentation/gpu/kms-properties.csv | 2 -
drivers/gpu/drm/Kconfig | 1 +
drivers/gpu/drm/display/Kconfig | 7 +
drivers/gpu/drm/display/Makefile | 2 +
drivers/gpu/drm/display/drm_hdmi_helper.c | 61 +
drivers/gpu/drm/display/drm_hdmi_state_helper.c | 716 ++++++++
drivers/gpu/drm/drm_atomic.c | 11 +
drivers/gpu/drm/drm_atomic_uapi.c | 4 +
drivers/gpu/drm/drm_connector.c | 194 +++
drivers/gpu/drm/drm_debugfs.c | 152 ++
drivers/gpu/drm/drm_mode_object.c | 1 +
drivers/gpu/drm/rockchip/Kconfig | 3 +
drivers/gpu/drm/rockchip/inno_hdmi.c | 172 +-
drivers/gpu/drm/sun4i/Kconfig | 3 +
drivers/gpu/drm/sun4i/sun4i_hdmi_enc.c | 84 +-
drivers/gpu/drm/tests/Makefile | 1 +
drivers/gpu/drm/tests/drm_connector_test.c | 1051 +++++++++++-
drivers/gpu/drm/tests/drm_hdmi_state_helper_test.c | 1743 ++++++++++++++++++++
drivers/gpu/drm/tests/drm_kunit_edid.h | 482 ++++++
drivers/gpu/drm/vc4/Kconfig | 1 +
drivers/gpu/drm/vc4/tests/vc4_mock.c | 6 +-
drivers/gpu/drm/vc4/tests/vc4_mock.h | 9 +-
drivers/gpu/drm/vc4/tests/vc4_mock_plane.c | 44 +-
drivers/gpu/drm/vc4/vc4_hdmi.c | 644 +-------
drivers/gpu/drm/vc4/vc4_hdmi.h | 44 +-
drivers/gpu/drm/vc4/vc4_hdmi_phy.c | 6 +-
include/drm/display/drm_hdmi_helper.h | 4 +
include/drm/display/drm_hdmi_state_helper.h | 23 +
include/drm/drm_connector.h | 229 +++
29 files changed, 4911 insertions(+), 789 deletions(-)
---
base-commit: 533db32499de1618443b2249bc20011cd5abc9d9
change-id: 20230814-kms-hdmi-connector-state-616787e67927
Best regards,
--
Maxime Ripard <mripard at kernel.org>
More information about the dri-devel
mailing list