[PATCH 8/8] accel/habanalabs: disable EQ interrupt after disabling pci

[Ofir Bitton]

From: Tal Cohen <talcohen at habana.ai>

When sending disable pci msg towards firmware, there is a
possibility that an EQ packet is already pending,
disabling EQ interrupt will prevent this from happening.
The interrupt will be re-enabled after reset.

Signed-off-by: Tal Cohen <talcohen at habana.ai>
Reviewed-by: Ofir Bitton <obitton at habana.ai>
---
 drivers/accel/habanalabs/common/device.c | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/drivers/accel/habanalabs/common/device.c b/drivers/accel/habanalabs/common/device.c
index 5ca7014def00..78e65c6b76a7 100644
--- a/drivers/accel/habanalabs/common/device.c
+++ b/drivers/accel/habanalabs/common/device.c
@@ -1502,10 +1502,11 @@ static void send_disable_pci_access(struct hl_device *hdev, u32 flags)
 		if (hl_fw_send_pci_access_msg(hdev, CPUCP_PACKET_DISABLE_PCI_ACCESS, 0x0))
 			return;
 
-		/* verify that last EQs are handled before disabled is set */
+		/* disable_irq also generates sync irq, this verifies that last EQs are handled
+		 * before disabled is set. The IRQ will be enabled again in request_irq call.
+		 */
 		if (hdev->cpu_queues_enable)
-			synchronize_irq(pci_irq_vector(hdev->pdev,
-					hdev->asic_prop.eq_interrupt_id));
+			disable_irq(pci_irq_vector(hdev->pdev, hdev->asic_prop.eq_interrupt_id));
 	}
 }
 
-- 
2.34.1