[PATCH v1] drm/bridge: simple-bridge: Add support for TI TDP158

[Dmitry Baryshkov]

On Tue, May 28, 2024 at 11:17:56AM +0200, Maxime Ripard wrote:
> On Tue, May 28, 2024 at 10:05:50AM GMT, Arnaud Vrac wrote:
> > On 28/05/2024 09:43, Maxime Ripard wrote:
> > > Hi,
> > > 
> > > On Mon, May 27, 2024 at 06:03:56PM GMT, Marc Gonzalez wrote:
> > > > From: Arnaud Vrac <avrac at freebox.fr>
> > > > 
> > > > The TI TDP158 is an AC-Coupled HDMI signal to TMDS Redriver supporting
> > > > DVI 1.0 and HDMI 1.4b and 2.0b output signals.
> > > > 
> > > > Since it's an I2C-programmable bridge, it could have a proper driver,
> > > > but the default settings work fine, thus simple bridge is sufficient.
> > > 
> > > No it doesn't. That bridge supports HDMI 2.0 which means you'll need to
> > > change the TMDS clock ratio when programming a TMDS character rate
> > > higher than 340MHz. And you'll need hotplug support to deal with it
> > > properly too.
> > > 
> > > So sorry, you need a real driver there.
> > 
> > Hello, this is an HDMI redriver, which simply cleans up the HDMI
> > signal, so no programming is needed to support HDMI 2.0.
> 
> I mean, if I'm to trust the datasheet, it is more complicated than that.
> It snoops the DDC bus so it can update the TMDS clock ratio bit if it's
> sent on its input side, but that wouldn't happen with DP for example.

If I understand correctly, this chip can work in two modes: dummy and
I2C-programmed. In the former case it is fully transparent, including
HPD passthrough, it doesn't require any additional programming, just
Vcc, Vdd and pin straps, etc.  And the second mode is a 'brainy' one,
when the chip is fully controlled over I2C.

>From the Linux standpoint these two modes will use single compat string,
but two distinct drivers: for the former mode is is enough to use
simple-bridge (fixed to support two supplies), while the latter one
needs a proper I2C driver.

Does that solve your concern?

-- 
With best wishes
Dmitry