[PATCH] drm/msm/hdmi: mark interlace_allowed as true

[Dmitry Baryshkov]

On Fri, 1 Nov 2024 at 23:41, Abhinav Kumar <quic_abhinavk at quicinc.com> wrote:
>
>
>
> On 10/18/2024 2:10 PM, Dmitry Baryshkov wrote:
> > The MSM HDMI driver supports interlaced modes. Set the corresponding
> > flag to allow interlaced modes on the corresponding connectors.
> >
> > Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
> > ---
> >   drivers/gpu/drm/msm/hdmi/hdmi_bridge.c | 1 +
> >   1 file changed, 1 insertion(+)
> >
> > diff --git a/drivers/gpu/drm/msm/hdmi/hdmi_bridge.c b/drivers/gpu/drm/msm/hdmi/hdmi_bridge.c
> > index 4a5b5112227f..643c152e6380 100644
> > --- a/drivers/gpu/drm/msm/hdmi/hdmi_bridge.c
> > +++ b/drivers/gpu/drm/msm/hdmi/hdmi_bridge.c
> > @@ -336,6 +336,7 @@ int msm_hdmi_bridge_init(struct hdmi *hdmi)
> >       bridge->funcs = &msm_hdmi_bridge_funcs;
> >       bridge->ddc = hdmi->i2c;
> >       bridge->type = DRM_MODE_CONNECTOR_HDMIA;
> > +     bridge->interlace_allowed = true;
> >       bridge->ops = DRM_BRIDGE_OP_HPD |
> >               DRM_BRIDGE_OP_DETECT |
> >               DRM_BRIDGE_OP_EDID;
> >
>
> I had quite a bit of discussion on this internally because this spans
> quite a few generations of chipsets.
>
> On very old hardware, even before msm8996, there was dedicated hardware
> de-interlacer. But even on msm8996 or other HDMI supported chipsets
> where the handling of if (mode->flags & DRM_MODE_FLAG_INTERLACE) is
> present, these were because its carry forward of older interface code.
>
> The way we handle interlaced formats today, is software needs to handle
> the part of dividing height / 2 and width * 2 and adjust the source crop
> if necessary. This part has moved to userspace for recent chips.
>
> Othwerise, we will need to add this part in the dpu driver to adjust
> this. I am not seeing this part there yet. So may I know how you
> validated this change? Something similar to :
>
> https://git.codelinaro.org/clo/la/kernel/msm-4.4/-/blob/caf_migration/LE.UM.1.3.r3.25/drivers/gpu/drm/msm/sde/sde_plane.c#L1340
>
> If we add this part first to dpu code, then we can mark interlace_allowed.

I think you are mixing the interlaced formats and interlaced output.
The code that you have pointed to is related to hardware deinterlacing
- in other words taking the interlaced framebuffer and outputting it
to the progressive display.

The interlace_allowed flag controls a different feature - filtering of
the internalced modes (aka 576i, 1080i, etc). In this case we are
using progressive frames, but the HDMI outputs a picture as two
separate fields. I have validated this by outputting image (modetest)
to the external HDMI display on IFC6410 and on DB820c boards.

-- 
With best wishes
Dmitry