[PATCH v2 13/14] drm/msm/dpu: support SSPP assignment for quad-pipe case

[Dmitry Baryshkov]

On Wed, Oct 09, 2024 at 04:50:26PM GMT, Jun Nie wrote:
> Support SSPP assignment for quad-pipe case with unified method.
> The first 2 pipes can share a set of mixer config and enable
> multi-rect mode if condition is met. It is also the case for
> the later 2 pipes.
> 
> Signed-off-by: Jun Nie <jun.nie at linaro.org>
> ---
>  drivers/gpu/drm/msm/disp/dpu1/dpu_plane.c | 85 +++++++++++++++----------------
>  1 file changed, 42 insertions(+), 43 deletions(-)
> 
> diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_plane.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_plane.c
> index 480a1b46aba72..23de2ca6fabb0 100644
> --- a/drivers/gpu/drm/msm/disp/dpu1/dpu_plane.c
> +++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_plane.c
> @@ -999,7 +999,7 @@ static int dpu_plane_atomic_check_pipes(struct drm_plane *plane,
>  		pipe = &pstate->pipe[i];
>  		pipe_cfg = &pstate->pipe_cfg[i];
>  		if (!pipe_cfg->valid || !pipe->sspp)
> -			break;
> +			continue;
>  		DPU_DEBUG_PLANE(pdpu, "pipe %d is in use, validate it\n", i);
>  		ret = dpu_plane_atomic_check_pipe(pdpu, pipe, pipe_cfg,
>  						  &crtc_state->adjusted_mode,
> @@ -1154,13 +1154,10 @@ static int dpu_plane_virtual_assign_resources(struct drm_crtc *crtc,
>  	struct dpu_kms *dpu_kms = _dpu_plane_get_kms(plane);
>  	struct dpu_rm_sspp_requirements reqs;
>  	struct dpu_plane_state *pstate;
> -	struct dpu_sw_pipe *pipe;
> -	struct dpu_sw_pipe *r_pipe;
> -	struct dpu_sw_pipe_cfg *pipe_cfg;
> -	struct dpu_sw_pipe_cfg *r_pipe_cfg;
> +	struct dpu_plane *pdpu = to_dpu_plane(plane);
>  	const struct msm_format *fmt;
>  	uint32_t max_linewidth;
> -	int i;
> +	int i, lm_num, lmcfg_id, lmcfg_num;
>  
>  	if (plane_state->crtc)
>  		crtc_state = drm_atomic_get_new_crtc_state(state,
> @@ -1168,12 +1165,6 @@ static int dpu_plane_virtual_assign_resources(struct drm_crtc *crtc,
>  
>  	pstate = to_dpu_plane_state(plane_state);
>  
> -	/* loop below code for another pair later */
> -	pipe = &pstate->pipe[0];
> -	r_pipe = &pstate->pipe[1];
> -	pipe_cfg = &pstate->pipe_cfg[0];
> -	r_pipe_cfg = &pstate->pipe_cfg[1];
> -
>  	for (i = 0; i < PIPES_PER_PLANE; i++)
>  		pstate->pipe[i].sspp = NULL;
>  
> @@ -1189,41 +1180,49 @@ static int dpu_plane_virtual_assign_resources(struct drm_crtc *crtc,
>  
>  	max_linewidth = dpu_kms->catalog->caps->max_linewidth;
>  
> -	pipe->sspp = dpu_rm_reserve_sspp(&dpu_kms->rm, global_state, crtc, &reqs);
> -	if (!pipe->sspp)
> -		return -ENODEV;
> -
> -	if (drm_rect_width(&r_pipe_cfg->src_rect) == 0) {
> -		pipe->multirect_index = DPU_SSPP_RECT_SOLO;
> -		pipe->multirect_mode = DPU_SSPP_MULTIRECT_NONE;
> -
> -		r_pipe->multirect_index = DPU_SSPP_RECT_SOLO;
> -		r_pipe->multirect_mode = DPU_SSPP_MULTIRECT_NONE;
> -
> -		r_pipe->sspp = NULL;
> -	} else {
> -		if (dpu_plane_is_multirect_parallel_capable(pipe, pipe_cfg, fmt, max_linewidth) &&
> -		    dpu_plane_is_multirect_parallel_capable(r_pipe, r_pipe_cfg, fmt, max_linewidth) &&
> -		    (test_bit(DPU_SSPP_SMART_DMA_V1, &pipe->sspp->cap->features) ||
> -		     test_bit(DPU_SSPP_SMART_DMA_V2, &pipe->sspp->cap->features))) {
> -			r_pipe->sspp = pipe->sspp;
> +	lm_num = dpu_crtc_get_lm_num(crtc_state);
> +	lmcfg_num = (lm_num + 1) / 2;
> +	for (lmcfg_id = 0; lmcfg_id < lmcfg_num; lmcfg_id++) {
> +		for (i = lmcfg_id * PIPES_PER_LM_PAIR; i < (lmcfg_id + 1) * PIPES_PER_LM_PAIR; i++) {
> +			struct dpu_sw_pipe *pipe = &pstate->pipe[i];
> +			struct dpu_sw_pipe *r_pipe = &pstate->pipe[i + 1];
> +			struct dpu_sw_pipe_cfg *pipe_cfg = &pstate->pipe_cfg[i];
> +			struct dpu_sw_pipe_cfg *r_pipe_cfg = &pstate->pipe_cfg[i + 1];
>  
> -			pipe->multirect_index = DPU_SSPP_RECT_0;
> -			pipe->multirect_mode = DPU_SSPP_MULTIRECT_PARALLEL;
> +			if (!pipe_cfg->valid)
> +				break;
>  
> -			r_pipe->multirect_index = DPU_SSPP_RECT_1;
> -			r_pipe->multirect_mode = DPU_SSPP_MULTIRECT_PARALLEL;
> -		} else {
> -			/* multirect is not possible, use two SSPP blocks */
> -			r_pipe->sspp = dpu_rm_reserve_sspp(&dpu_kms->rm, global_state, crtc, &reqs);
> -			if (!r_pipe->sspp)
> +			pipe->sspp = dpu_rm_reserve_sspp(&dpu_kms->rm, global_state, crtc, &reqs);
> +			if (!pipe->sspp)
>  				return -ENODEV;
>  
> -			pipe->multirect_index = DPU_SSPP_RECT_SOLO;
> -			pipe->multirect_mode = DPU_SSPP_MULTIRECT_NONE;
> -
> -			r_pipe->multirect_index = DPU_SSPP_RECT_SOLO;
> -			r_pipe->multirect_mode = DPU_SSPP_MULTIRECT_NONE;
> +			/*
> +			 * If current pipe is the first pipe in pipe pair, check
> +			 * multi-rect opportunity for the 2nd pipe in the pair.
> +			 * SSPP multi-rect mode cross mixer pairs is not supported.
> +			 */
> +			if (!(i % 2) &&

if ((i % PIPES_PER_LM_PAIR == 0) &&

> +			    r_pipe_cfg->valid &&
> +			    drm_rect_width(&r_pipe_cfg->src_rect) != 0 &&
> +			    dpu_plane_is_multirect_parallel_capable(pipe, pipe_cfg, fmt, max_linewidth) &&
> +			    dpu_plane_is_multirect_parallel_capable(r_pipe, r_pipe_cfg, fmt, max_linewidth) &&
> +			    (test_bit(DPU_SSPP_SMART_DMA_V1, &pipe->sspp->cap->features) ||
> +			     test_bit(DPU_SSPP_SMART_DMA_V2, &pipe->sspp->cap->features))) {
> +				pipe->multirect_index = DPU_SSPP_RECT_0;
> +				pipe->multirect_mode = DPU_SSPP_MULTIRECT_PARALLEL;
> +
> +				DPU_DEBUG_PLANE(pdpu, "allocating sspp_%d for pipe %d and set pipe %d as multi-rect\n",
> +						pipe->sspp->idx - SSPP_NONE, i, i + 1);
> +				r_pipe->sspp = pipe->sspp;
> +				r_pipe->multirect_index = DPU_SSPP_RECT_1;
> +				r_pipe->multirect_mode = DPU_SSPP_MULTIRECT_PARALLEL;
> +				i++;
> +			} else {
> +				pipe->multirect_index = DPU_SSPP_RECT_SOLO;
> +				pipe->multirect_mode = DPU_SSPP_MULTIRECT_NONE;
> +				DPU_DEBUG_PLANE(pdpu, "allocating sspp_%d for pipe %d.\n",
> +						pipe->sspp->idx - SSPP_NONE, i);
> +			}
>  		}
>  	}
>  
> 
> -- 
> 2.34.1
> 

-- 
With best wishes
Dmitry