[PATCH v4 10/11] drm/bridge: anx7625: fix anx7625_sink_detect() to return correct hpd status

[Dmitry Baryshkov]

On Thu, Apr 17, 2025 at 11:09:08AM +0530, Ayushi Makhija wrote:
> From: Ayushi Makhija <quic_amakhija at quicinc.com>
> 
> In the anx7625_sink_detect(), the device is checked to see
> if it is a panel bridge, and it always sends a "connected"
> status to the connector. When adding the DP port on port 1 of the
> anx7625, it incorrectly treats it as a panel bridge and sends an
> always "connected" status. Instead of checking the status on the
> panel bridge, it's better to check the hpd_status for connectors
> that supports hot-plugging. This way, it verifies the hpd_status
> variable before sending the status to the connector.

Does this work if the Analogix bridge is connected to an eDP panel? In
such a case it should report 'connected' even before powering up the
panel (which might mean HPD pin being low).

> 
> Signed-off-by: Ayushi Makhija <quic_amakhija at quicinc.com>
> Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov at oss.qualcomm.com>
> ---
>  drivers/gpu/drm/bridge/analogix/anx7625.c | 3 ---
>  1 file changed, 3 deletions(-)
> 
> diff --git a/drivers/gpu/drm/bridge/analogix/anx7625.c b/drivers/gpu/drm/bridge/analogix/anx7625.c
> index a32ebe1fa0cd..365d1c871028 100644
> --- a/drivers/gpu/drm/bridge/analogix/anx7625.c
> +++ b/drivers/gpu/drm/bridge/analogix/anx7625.c
> @@ -1814,9 +1814,6 @@ static enum drm_connector_status anx7625_sink_detect(struct anx7625_data *ctx)
>  
>  	DRM_DEV_DEBUG_DRIVER(dev, "sink detect\n");
>  
> -	if (ctx->pdata.panel_bridge)
> -		return connector_status_connected;
> -
>  	return ctx->hpd_status ? connector_status_connected :
>  				     connector_status_disconnected;
>  }
> -- 
> 2.34.1
> 

-- 
With best wishes
Dmitry