[PATCH v3 5/6] drm/bridge: imx: add driver for HDMI TX Parallel Audio Interface

[Liu Ying]

On 08/06/2025, Shengjiu Wang wrote:
> On Tue, Aug 5, 2025 at 4:55 PM Liu Ying <victor.liu at nxp.com> wrote:
>>
>> On 08/04/2025, Shengjiu Wang wrote:

[...]

>>> +#define HTX_PAI_STAT                 0x0c
>>> +#define HTX_PAI_IRQ_NOMASK           0x10
>>> +#define HTX_PAI_IRQ_MASKED           0x14
>>> +#define HTX_PAI_IRQ_MASK             0x18
>>
>> The above 4 registers are not pratically used.  Drop.
> 
> They are used by regmap to make a full definition.

Yes, but they are not pratically used for interrupt support.
Once you add interrupt support in this driver, you may add these registers.

[...]

>>> +             /* PCM choose 24bit*/
>>> +             val = FIELD_PREP(D_SEL, width - 24);
>>
>> Why 'width - 24'?  Can it be expressed by a helper or macro?
> 
>                 /*
>                  * The allowed width are 24bit and 32bit, as they are
> supported by
>                  * aud2htx module.
>                  * for 24bit, D_SEL = 0, select all the bits.
>                  * for 32bit, D_SEL = 8, select the MSB.
>                  */
> will add such comments.

Fine for me(Not an audio guy though).

-- 
Regards,
Liu Ying