[PATCH] reset: eyeq: drop device_set_of_node_from_dev() done by parent

[Théo Lebrun]

Our parent driver (clk-eyeq) now does the
	device_set_of_node_from_dev(dev, dev->parent)
call through the newly introduced devm_auxiliary_device_create() helper.

Doing it again in the reset-eyeq probe would be redundant.
Drop both the WARN_ON() and the device_set_of_node_from_dev() call.
Also fix the following comment that talks about "our newfound OF node".

Signed-off-by: Théo Lebrun <theo.lebrun at bootlin.com>
---
 drivers/reset/reset-eyeq.c | 13 ++-----------
 1 file changed, 2 insertions(+), 11 deletions(-)

diff --git a/drivers/reset/reset-eyeq.c b/drivers/reset/reset-eyeq.c
index 02d50041048b..8018fa895427 100644
--- a/drivers/reset/reset-eyeq.c
+++ b/drivers/reset/reset-eyeq.c
@@ -420,17 +420,8 @@ static int eqr_probe(struct auxiliary_device *adev,
 	int ret;
 
 	/*
-	 * We are an auxiliary device of clk-eyeq. We do not have an OF node by
-	 * default; let's reuse our parent's OF node.
-	 */
-	WARN_ON(dev->of_node);
-	device_set_of_node_from_dev(dev, dev->parent);
-	if (!dev->of_node)
-		return -ENODEV;
-
-	/*
-	 * Using our newfound OF node, we can get match data. We cannot use
-	 * device_get_match_data() because it does not match reused OF nodes.
+	 * Get match data. We cannot use device_get_match_data() because it does
+	 * not accept reused OF nodes; see device_set_of_node_from_dev().
 	 */
 	match = of_match_node(dev->driver->of_match_table, dev->of_node);
 	if (!match || !match->data)
-- 
2.48.1