[PATCH v4 20/20] gpu: nova-core: load and run FWSEC-FRTS

[Timur Tabi]

On Wed, 2025-05-21 at 15:45 +0900, Alexandre Courbot wrote:

I noticed something interesting in this change to Gpu::new().

> +        // Check that the WPR2 region does not already exists - if it does, the GPU needs to be
> +        // reset.
> +        if regs::NV_PFB_PRI_MMU_WPR2_ADDR_HI::read(bar).hi_val() != 0 {
> +            dev_err!(
> +                pdev.as_ref(),
> +                "WPR2 region already exists - GPU needs to be reset to proceed\n"
> +            );
> +            return Err(EBUSY);
> +        }

You have a lot of checks in this code that display an error message and then return an Err().

But then ...

> +
> +        // Reset falcon, load FWSEC-FRTS, and run it.
> +        gsp_falcon.reset(bar)?;
> +        gsp_falcon.dma_load(bar, &fwsec_frts)?;
> +        let (mbox0, _) = gsp_falcon.boot(bar, Some(0), None)?;
> +        if mbox0 != 0 {
> +            dev_err!(pdev.as_ref(), "FWSEC firmware returned error {}\n", mbox0);
> +            return Err(EINVAL);
> +        }

There are several lines where you just terminate them with "?".  This means that no error message is
displays. 

I think all of these ? should be replaced with something like:

	gsp_falcon.reset(bar).inspect_err(|e| {
            dev_err!(pdev.as_ref(), "Failed to reset GSP falcon: {:?}\n", e);
        })?;

This feels like something that would benefit from a macro, but I can't imagine what that would look
like.