[PATCH 2/6] etnaviv: use padded width/height for resource copies

[Lucas Stach]

When copying a resource fully we can just blit the whole level. This allows
to use the RS even for level sizes not aligned to the RS min alignment. This
is especially useful, as etna_copy_resource is part of the software fallback
paths (used in etna_transfer), that are used for doing unaligned copies.

Signed-off-by: Lucas Stach <dev at lynxeye.de>
---
 src/gallium/drivers/etnaviv/etnaviv_clear_blit.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/src/gallium/drivers/etnaviv/etnaviv_clear_blit.c b/src/gallium/drivers/etnaviv/etnaviv_clear_blit.c
index 6844943..263b283 100644
--- a/src/gallium/drivers/etnaviv/etnaviv_clear_blit.c
+++ b/src/gallium/drivers/etnaviv/etnaviv_clear_blit.c
@@ -626,9 +626,9 @@ etna_copy_resource(struct pipe_context *pctx, struct pipe_resource *dst,
    for (int level = first_level; level <= last_level; level++) {
       blit.src.level = blit.dst.level = level;
       blit.src.box.width = blit.dst.box.width =
-         MIN2(src_priv->levels[level].width, dst_priv->levels[level].width);
+         MIN2(src_priv->levels[level].padded_width, dst_priv->levels[level].padded_width);
       blit.src.box.height = blit.dst.box.height =
-         MIN2(src_priv->levels[level].height, dst_priv->levels[level].height);
+         MIN2(src_priv->levels[level].padded_height, dst_priv->levels[level].padded_height);
 
       for (int layer = 0; layer < dst->array_size; layer++) {
          blit.src.box.z = blit.dst.box.z = layer;
-- 
2.9.4