[PATCH 1/2] drm/etnaviv: reduce reset delay

[Philipp Zabel]

After reset assertion, we only have to wait for the reset signals to
propagate through the GPU before deasserting the reset again. A few
hundred clock cycles should be more than enough. Replace the msleep(1),
which can actually take about 30 ms on i.MX6Q in some configurations,
with an usleep_range of a few microseconds. If the delay was too short,
the FE would not be idle afterwards, and the reset would be retried.

Signed-off-by: Philipp Zabel <p.zabel at pengutronix.de>
---
 drivers/gpu/drm/etnaviv/etnaviv_gpu.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/gpu/drm/etnaviv/etnaviv_gpu.c b/drivers/gpu/drm/etnaviv/etnaviv_gpu.c
index fc9a6a83dfc77..9f7999552cc31 100644
--- a/drivers/gpu/drm/etnaviv/etnaviv_gpu.c
+++ b/drivers/gpu/drm/etnaviv/etnaviv_gpu.c
@@ -461,7 +461,7 @@ static int etnaviv_hw_reset(struct etnaviv_gpu *gpu)
 		gpu_write(gpu, VIVS_HI_CLOCK_CONTROL, control);
 
 		/* wait for reset. */
-		msleep(1);
+		usleep_range(10, 20);
 
 		/* reset soft reset bit. */
 		control &= ~VIVS_HI_CLOCK_CONTROL_SOFT_RESET;
-- 
2.11.0