[fprint] AuthenTec 08ff:2665

[Ted To]

BTW, if it is important, I am running Debian Jessie.

On 2016-03-31 11:10 pm, Ted To wrote:
> I am.  It is ./autogen.sh that is calling configure.
> 
> On 03/31/2016 11:06 PM, Vasily Khoruzhick wrote:
>> Run ./autogen.sh before running configure.
>> 
>> On Thu, Mar 31, 2016 at 7:24 PM, Ted To <wintrymix at theo.to> wrote:
>>> Thanks Vasily, I'm trying it but I'm getting a dependency problem.  I
>>> installed libusb-1.0-0-dev but I'm still getting an error when 
>>> running
>>> autogen.sh.  In particular,
>>> 
>>> ./configure: line 15610: syntax error near unexpected token `LIBUSB,'
>>> ./configure: line 15610: `PKG_CHECK_MODULES(LIBUSB, libusb-1.0 >= 
>>> 0.9.1)'
>>> 
>>> Any suggestions?
>>> 
>>> Thanks,
>>> Ted
>>> 
>>> 
>>> On 2016-03-31 10:02 pm, Vasily Khoruzhick wrote:
>>>> 
>>>> Hi Ted,
>>>> 
>>>> It's very likely that it's already supported by aes2660 driver. Try
>>>> adding your device id into id_table in libfprint/drivers/aes2660.c
>>>> 
>>>> Regards,
>>>> Vasily
>>>> 
>>>> On Thu, Mar 31, 2016 at 6:17 PM, Ted To <wintrymix at theo.to> wrote:
>>>>> 
>>>>> Hi,
>>>>> 
>>>>> Are there any plans to write a driver for the AuthenTec 08ff:2665?  
>>>>> I am
>>>>> more than happy to help test/debug.  I have an HP Pavilion 
>>>>> DM4-3050us.
>>>>> 
>>>>> Thanks,
>>>>> Ted To
>>>>> 
>>>>> _______________________________________________
>>>>> fprint mailing list
>>>>> fprint at lists.freedesktop.org
>>>>> https://lists.freedesktop.org/mailman/listinfo/fprint