[Freedreno] [Patch v15 2/5] iommu/arm-smmu: Invoke pm_runtime during probe, add/remove device

[Tomasz Figa]

On Thu, Aug 30, 2018 at 6:22 PM Vivek Gautam
<vivek.gautam at codeaurora.org> wrote:
>
> On Mon, Aug 27, 2018 at 4:27 PM Vivek Gautam
> <vivek.gautam at codeaurora.org> wrote:
> >
> > From: Sricharan R <sricharan at codeaurora.org>
> >
> > The smmu device probe/remove and add/remove master device callbacks
> > gets called when the smmu is not linked to its master, that is without
> > the context of the master device. So calling runtime apis in those places
> > separately.
> >
> > Signed-off-by: Sricharan R <sricharan at codeaurora.org>
> > [vivek: Cleanup pm runtime calls]
> > Signed-off-by: Vivek Gautam <vivek.gautam at codeaurora.org>
> > Reviewed-by: Tomasz Figa <tfiga at chromium.org>
> > Tested-by: Srinivas Kandagatla <srinivas.kandagatla at linaro.org>
> > ---
> >
> > Changes since v14:
> >  - none.
> >
> >  drivers/iommu/arm-smmu.c | 101 +++++++++++++++++++++++++++++++++++++++++++----
> >  1 file changed, 93 insertions(+), 8 deletions(-)
> >
> > diff --git a/drivers/iommu/arm-smmu.c b/drivers/iommu/arm-smmu.c
> > index a81224bc6637..23b4a60149b6 100644
> > --- a/drivers/iommu/arm-smmu.c
> > +++ b/drivers/iommu/arm-smmu.c
>
> [snip]
>
> > @@ -2131,6 +2188,26 @@ static int arm_smmu_device_probe(struct platform_device *pdev)
> >         if (err)
> >                 return err;
> >
> > +       /*
> > +        * We want to avoid touching dev->power.lock in fastpaths unless
> > +        * it's really going to do something useful - pm_runtime_enabled()
> > +        * can serve as an ideal proxy for that decision. So, conditionally
> > +        * enable pm_runtime.
> > +        */
> > +       if (dev->pm_domain)
> > +               pm_runtime_enable(dev);
> > +
> > +       err = arm_smmu_rpm_get(smmu);
>
> We shouldn't be doing a runtime_get() yet, as this eventually calls
> arm_smmu_device_reset().
> arm_smmu_device_reset() should be called only after arm_smmu_device_cfg_probe().
> So, I plan to replace the pm_runtime_get/put() calls in probe() with
> simple clk_bulk_enable()
> to let the driver initialize smmu, and at the end of the probe we can
> disable the clocks and
> enable runtime pm over the device to let it take care of the device further-on.
>

We can avoid the explicit clock disable by just calling
pm_runtime_set_active() before pm_runtime_enable(), assuming that what
probe does is symmetrical with the suspend callback, which would be
called after the latter.

Best regards,
Tomasz