[Freedreno] [PATCH 1/1] drm/msm/a6xx: Add support for an interconnect path

[Georgi Djakov]

Hi Jordan,

Thanks for the patch!

On 11/29/18 19:26, Jordan Crouse wrote:
> Try to get the interconnect path for the GPU and vote for the maximum
> bandwidth to support all frequencies. This is needed for performance.
> Later we will want to scale the bandwidth based on the frequency to
> also optimize for power but that will require some device tree
> infrastructure that does not yet exist.
> 
> v3: Absolute bandwidth values should be specified in KBps

btw. now i have also included macros in the header, that can be used to
specify the bandwidth units. So now you can now use kBps_to_icc or
MBps_to_icc etc. If we decide at some point that we change the units we
use internally, we will not have update all the users.

> 
> Signed-off-by: Jordan Crouse <jcrouse at codeaurora.org>
> ---
>  drivers/gpu/drm/msm/adreno/a6xx_gmu.c   | 20 ++++++++++++++++++++
>  drivers/gpu/drm/msm/adreno/adreno_gpu.c |  9 +++++++++
>  drivers/gpu/drm/msm/msm_gpu.h           |  3 +++
>  3 files changed, 32 insertions(+)
> 
> diff --git a/drivers/gpu/drm/msm/adreno/a6xx_gmu.c b/drivers/gpu/drm/msm/adreno/a6xx_gmu.c
> index 546599a7ab05..fe0f5b10fd9c 100644
> --- a/drivers/gpu/drm/msm/adreno/a6xx_gmu.c
> +++ b/drivers/gpu/drm/msm/adreno/a6xx_gmu.c
> @@ -3,6 +3,7 @@
>  
>  #include <linux/clk.h>
>  #include <linux/pm_opp.h>
> +#include <linux/interconnect.h>
>  #include <soc/qcom/cmd-db.h>

Alphabetic order maybe?

>  #include "a6xx_gpu.h"
> @@ -63,6 +64,9 @@ static bool a6xx_gmu_gx_is_on(struct a6xx_gmu *gmu)
>  
>  static void __a6xx_gmu_set_freq(struct a6xx_gmu *gmu, int index)
>  {
> +	struct a6xx_gpu *a6xx_gpu = container_of(gmu, struct a6xx_gpu, gmu);
> +	struct adreno_gpu *adreno_gpu = &a6xx_gpu->base;
> +	struct msm_gpu *gpu = &adreno_gpu->base;
>  	int ret;
>  
>  	gmu_write(gmu, REG_A6XX_GMU_DCVS_ACK_OPTION, 0);
> @@ -85,6 +89,12 @@ static void __a6xx_gmu_set_freq(struct a6xx_gmu *gmu, int index)
>  		dev_err(gmu->dev, "GMU set GPU frequency error: %d\n", ret);
>  
>  	gmu->freq = gmu->gpu_freqs[index];
> +
> +	/*
> +	 * Eventually we will want to scale the path vote with the frequency but
> +	 * for now leave it t at max so that the performance is nominal.

An extra t above.

> +	 */
> +	icc_set(gpu->icc_path, 0, 7216000);
>  }
>  
>  void a6xx_gmu_set_freq(struct msm_gpu *gpu, unsigned long freq)
> @@ -680,6 +690,8 @@ int a6xx_gmu_reset(struct a6xx_gpu *a6xx_gpu)
>  
>  int a6xx_gmu_resume(struct a6xx_gpu *a6xx_gpu)
>  {
> +	struct adreno_gpu *adreno_gpu = &a6xx_gpu->base;
> +	struct msm_gpu *gpu = &adreno_gpu->base;
>  	struct a6xx_gmu *gmu = &a6xx_gpu->gmu;
>  	int status, ret;
>  
> @@ -695,6 +707,9 @@ int a6xx_gmu_resume(struct a6xx_gpu *a6xx_gpu)
>  	if (ret)
>  		goto out;
>  
> +	/* Set the bus quota to a reasonable value for boot */
> +	icc_set(gpu->icc_path, 0, 3072000);

Here you can do:
	icc_set(gpu->icc_path, 0, MBps_to_icc(3072));

> +
>  	a6xx_gmu_irq_enable(gmu);
>  
>  	/* Check to see if we are doing a cold or warm boot */
> @@ -735,6 +750,8 @@ bool a6xx_gmu_isidle(struct a6xx_gmu *gmu)
>  
>  int a6xx_gmu_stop(struct a6xx_gpu *a6xx_gpu)
>  {
> +	struct adreno_gpu *adreno_gpu = &a6xx_gpu->base;
> +	struct msm_gpu *gpu = &adreno_gpu->base;
>  	struct a6xx_gmu *gmu = &a6xx_gpu->gmu;
>  	u32 val;
>  
> @@ -781,6 +798,9 @@ int a6xx_gmu_stop(struct a6xx_gpu *a6xx_gpu)
>  	/* Tell RPMh to power off the GPU */
>  	a6xx_rpmh_stop(gmu);
>  
> +	/* Remove the bus vote */
> +	icc_set(gpu->icc_path, 0, 0);
> +
>  	clk_bulk_disable_unprepare(gmu->nr_clocks, gmu->clocks);
>  
>  	pm_runtime_put_sync(gmu->dev);
> diff --git a/drivers/gpu/drm/msm/adreno/adreno_gpu.c b/drivers/gpu/drm/msm/adreno/adreno_gpu.c
> index 93d70f4a2154..9bab491912cf 100644
> --- a/drivers/gpu/drm/msm/adreno/adreno_gpu.c
> +++ b/drivers/gpu/drm/msm/adreno/adreno_gpu.c
> @@ -21,6 +21,7 @@
>  #include <linux/kernel.h>
>  #include <linux/pm_opp.h>
>  #include <linux/slab.h>
> +#include <linux/interconnect.h>

Alphabetic order?

>  #include "adreno_gpu.h"
>  #include "msm_gem.h"
>  #include "msm_mmu.h"
> @@ -695,6 +696,11 @@ static int adreno_get_pwrlevels(struct device *dev,
>  
>  	DBG("fast_rate=%u, slow_rate=27000000", gpu->fast_rate);
>  
> +	/* Check for an interconnect path for the bus */
> +	gpu->icc_path = of_icc_get(dev, "port0");

I was wondering if port0 is appropriate name here. I assume this is the
port to DDR. Maybe we could name it gfx-mem or gpu-mem. Are there any
other interconnects that need to be scaled on the a6xx?

> +	if (IS_ERR(gpu->icc_path))
> +		gpu->icc_path = NULL;
> +
>  	return 0;
>  }
>  
> @@ -733,10 +739,13 @@ int adreno_gpu_init(struct drm_device *drm, struct platform_device *pdev,
>  
>  void adreno_gpu_cleanup(struct adreno_gpu *adreno_gpu)
>  {
> +	struct msm_gpu *gpu = &adreno_gpu->base;
>  	unsigned int i;
>  
>  	for (i = 0; i < ARRAY_SIZE(adreno_gpu->info->fw); i++)
>  		release_firmware(adreno_gpu->fw[i]);
>  
> +	icc_put(gpu->icc_path);
> +
>  	msm_gpu_cleanup(&adreno_gpu->base);
>  }
> diff --git a/drivers/gpu/drm/msm/msm_gpu.h b/drivers/gpu/drm/msm/msm_gpu.h
> index f82bac086666..7b04d1665555 100644
> --- a/drivers/gpu/drm/msm/msm_gpu.h
> +++ b/drivers/gpu/drm/msm/msm_gpu.h
> @@ -20,6 +20,7 @@
>  
>  #include <linux/clk.h>
>  #include <linux/regulator/consumer.h>
> +#include <linux/interconnect.h>

Alphabetic order?

>  
>  #include "msm_drv.h"
>  #include "msm_fence.h"
> @@ -119,6 +120,8 @@ struct msm_gpu {
>  	struct clk *ebi1_clk, *core_clk, *rbbmtimer_clk;
>  	uint32_t fast_rate;
>  
> +	struct icc_path *icc_path;
> +
>  	/* Hang and Inactivity Detection:
>  	 */
>  #define DRM_MSM_INACTIVE_PERIOD   66 /* in ms (roughly four frames) */

Can this driver be a module or is always built-in? If it is built-in and
the interconnect support is a module we will have a problem. Maybe add
something like this in the Kconfig:
	depends on INTERCONNECT || !INTERCONNECT

Thanks,
Georgi