[Freedreno] [PATCH v13 3/3] dt-bindings: drm/bridge: Document sn65dsi86 bridge bindings

[Rob Herring]

On Wed, Jun 27, 2018 at 03:27:35PM +0530, Sandeep Panda wrote:
> Document the bindings used for the sn65dsi86 DSI to eDP bridge.
> 
> Changes in v1:
>  - Rephrase the dt-binding descriptions to be more inline with existing
>    bindings (Andrzej Hajda).
>  - Add missing dt-binding that are parsed by corresponding driver
>    (Andrzej Hajda).
> 
> Changes in v2:
>  - Remove edp panel specific dt-binding entries. Only keep bridge
>    specific entries (Sean Paul).
>  - Remove custom-modes dt entry since its usage is removed from driver also (Sean Paul).
>  - Remove is-pluggable dt entry since this will not be needed anymore (Sean Paul).
> 
> Changes in v3:
>  - Remove irq-gpio dt entry and instead populate is an interrupt
>    property (Rob Herring).
> 
> Changes in v4:
>  - Add link to bridge chip datasheet (Stephen Boyd)
>  - Add vpll and vcc regulator supply bindings (Stephen Boyd)
>  - Add ref clk optional dt binding (Stephen Boyd)
>  - Add gpio-controller optional dt binding (Stephen Boyd)
> 
> Changes in v5:
>  - Use clock property to specify the input refclk (Stephen Boyd).
>  - Update gpio cell and pwm cell numbers (Stephen Boyd).
> 
> Changes in v6:
>  - Add property to mention the lane mapping scheme and polarity inversion
>    (Stephen Boyd).
> 
> Changes in v7:
>  - Detail description of lane mapping scheme dt property (Andrzej
>    Hajda/ Rob Herring).
>  - Removed HDP gpio binding, since the bridge uses IRQ signal to
>    determine HPD, and IRQ property is already documented in binding.
> 
> Changes in v8:
>  - Removed unnecessary explanation of lane mapping and polarity dt
>    property, since these are already explained in media/video-interface
>    dt binidng (Rob Herring).
> 
> Changes in v9:
>  - Avoid putting re-definition of lane mapping and polarity dt binding
>    (Rob Herring).
> 
> Changes in v10:
>  - Use interrupts-extended property instead of interrupts to specify
>    interrupt line (Andrzej Hajda).
>  - Move data-lanes and lane-polarity property example to proper place (Andrzej Hajda).
> 
> Changes in v11:
>  - Add a property for suspend gpio function of GPIO1 pin on bridge chip
>    (Stephen Boyd).
> 
> Signed-off-by: Sandeep Panda <spanda at codeaurora.org>
> ---
>  .../bindings/display/bridge/ti,sn65dsi86.txt       | 89 ++++++++++++++++++++++
>  1 file changed, 89 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/display/bridge/ti,sn65dsi86.txt

Reviewed-by: Rob Herring <robh at kernel.org>