[Freedreno] [PATCH 2/4] drm/msm/dsi_pll_10nm: restore VCO rate during restore_state

[Dmitry Baryshkov]

PHY disable/enable resets PLL registers to default values. Thus in
addition to restoring several registers we also need to restore VCO rate
settings.

Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
Fixes: c6659785dfb3 ("drm/msm/dsi/pll: call vco set rate explicitly")
---
 drivers/gpu/drm/msm/dsi/pll/dsi_pll_10nm.c | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/drivers/gpu/drm/msm/dsi/pll/dsi_pll_10nm.c b/drivers/gpu/drm/msm/dsi/pll/dsi_pll_10nm.c
index 6ac04fc303f5..e4e9bf04b736 100644
--- a/drivers/gpu/drm/msm/dsi/pll/dsi_pll_10nm.c
+++ b/drivers/gpu/drm/msm/dsi/pll/dsi_pll_10nm.c
@@ -559,6 +559,7 @@ static int dsi_pll_10nm_restore_state(struct msm_dsi_pll *pll)
 	struct pll_10nm_cached_state *cached = &pll_10nm->cached_state;
 	void __iomem *phy_base = pll_10nm->phy_cmn_mmio;
 	u32 val;
+	int ret;
 
 	val = pll_read(pll_10nm->mmio + REG_DSI_10nm_PHY_PLL_PLL_OUTDIV_RATE);
 	val &= ~0x3;
@@ -573,6 +574,13 @@ static int dsi_pll_10nm_restore_state(struct msm_dsi_pll *pll)
 	val |= cached->pll_mux;
 	pll_write(phy_base + REG_DSI_10nm_PHY_CMN_CLK_CFG1, val);
 
+	ret = dsi_pll_10nm_vco_set_rate(&pll->clk_hw, pll_10nm->vco_current_rate, pll_10nm->vco_ref_clk_rate);
+	if (ret) {
+		DRM_DEV_ERROR(&pll_10nm->pdev->dev,
+			"restore vco rate failed. ret=%d\n", ret);
+		return ret;
+	}
+
 	DBG("DSI PLL%d", pll_10nm->id);
 
 	return 0;
-- 
2.28.0