[Freedreno] [PATCH v2 1/2] drm/msm/dp: return fail when both link lane and rate are 0 at dpcd read

[Kuogee Hsieh]

Some dongle set both link lane and rate to 0 during dpcd receiver
capability read if there is no monitor attache to this dongle.
Therefore return fail to prevent driver from trying to populate
monitor further.

Changes in V2:
-- split this patch into two. Move postpone irq_handle into next patch
-- add Fixes tag

Fixes: 78f94fbb6122 ("drm/msm/dp: fix connect/disconnect handled at irq_hpd")

Signed-off-by: Kuogee Hsieh <khsieh at codeaurora.org>
---
 drivers/gpu/drm/msm/dp/dp_panel.c | 12 +++++++++---
 1 file changed, 9 insertions(+), 3 deletions(-)

diff --git a/drivers/gpu/drm/msm/dp/dp_panel.c b/drivers/gpu/drm/msm/dp/dp_panel.c
index 97dca3e..d1780bc 100644
--- a/drivers/gpu/drm/msm/dp/dp_panel.c
+++ b/drivers/gpu/drm/msm/dp/dp_panel.c
@@ -167,12 +167,18 @@ int dp_panel_read_sink_caps(struct dp_panel *dp_panel,
 	panel = container_of(dp_panel, struct dp_panel_private, dp_panel);
 
 	rc = dp_panel_read_dpcd(dp_panel);
+	if (rc) {
+		DRM_ERROR("read dpcd failed %d\n", rc);
+		return rc;
+	}
+
 	bw_code = drm_dp_link_rate_to_bw_code(dp_panel->link_info.rate);
-	if (rc || !is_link_rate_valid(bw_code) ||
+	if (!is_link_rate_valid(bw_code) ||
 			!is_lane_count_valid(dp_panel->link_info.num_lanes) ||
 			(bw_code > dp_panel->max_bw_code)) {
-		DRM_ERROR("read dpcd failed %d\n", rc);
-		return rc;
+		DRM_ERROR("Illegal link rate=%d lane=%d\n", dp_panel->link_info.rate,
+				dp_panel->link_info.num_lanes);
+		return -EINVAL;
 	}
 
 	if (dp_panel->dfp_present) {
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project