[Freedreno] [PATCH v2 09/11] drm/msm/disp/dpu1: Add support for DSC in topology

[Dmitry Baryshkov]

On 07/10/2021 10:08, Vinod Koul wrote:
> For DSC to work we typically need a 2,2,1 configuration. This should
> suffice for resolutions upto 4k. For more resolutions like 8k this won't
> work.
> 
> Also, it is better to use 2 LMs and DSC instances as half width results
> in lesser power consumption as compared to single LM, DSC at full width.
> 
> The panel has been tested only with 2,2,1 configuration, so for
> now we blindly create 2,2,1 topology when DSC is enabled
> 
> Co-developed-by: Abhinav Kumar <abhinavk at codeaurora.org>
> Signed-off-by: Abhinav Kumar <abhinavk at codeaurora.org>
> Signed-off-by: Vinod Koul <vkoul at kernel.org>
> ---
> Changes since
> RFC:
>   - Add more details in changelog
> 
>   drivers/gpu/drm/msm/disp/dpu1/dpu_encoder.c | 16 ++++++++++++++++
>   1 file changed, 16 insertions(+)
> 
> diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder.c
> index aac51c1bdf94..70f57a071165 100644
> --- a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder.c
> +++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder.c
> @@ -538,6 +538,8 @@ static struct msm_display_topology dpu_encoder_get_topology(
>   			struct drm_display_mode *mode)
>   {
>   	struct msm_display_topology topology = {0};
> +	struct drm_encoder *drm_enc;
> +	struct msm_drm_private *priv;
>   	int i, intf_count = 0;
>   
>   	for (i = 0; i < MAX_PHYS_ENCODERS_PER_VIRTUAL; i++)
> @@ -572,8 +574,22 @@ static struct msm_display_topology dpu_encoder_get_topology(
>   	topology.num_enc = 0;
>   	topology.num_intf = intf_count;
>   
> +	drm_enc = &dpu_enc->base;
> +	priv = drm_enc->dev->dev_private;
> +	if (priv && priv->dsc) {
> +		/* In case of Display Stream Compression DSC, we would use
> +		 * 2 encoders, 2 line mixers and 1 interface
> +		 * this is power optimal and can drive upto (including) 4k
> +		 * screens
> +		 */
> +		topology.num_enc = 2;
> +		topology.num_intf = 1;
> +		topology.num_lm = 2;

So, here you'd set the topology.num_rm.

> +	}
> +
>   	return topology;
>   }
> +
>   static int dpu_encoder_virt_atomic_check(
>   		struct drm_encoder *drm_enc,
>   		struct drm_crtc_state *crtc_state,
> 


-- 
With best wishes
Dmitry