[Freedreno] [v6, 02/21] drm/bridge: adv7511: Register and attach our DSI device at probe

[Marek Szyprowski]

Hi Mexime,

On 29.10.2021 10:05, Maxime Ripard wrote:
> On Fri, Oct 29, 2021 at 08:23:45AM +0200, Marek Szyprowski wrote:
>> On 25.10.2021 17:15, Maxime Ripard wrote:
>>> In order to avoid any probe ordering issue, the best practice is to move
>>> the secondary MIPI-DSI device registration and attachment to the
>>> MIPI-DSI host at probe time. Let's do this.
>>>
>>> Acked-by: Sam Ravnborg <sam at ravnborg.org>
>>> Tested-by: John Stultz <john.stultz at linaro.org>
>>> Signed-off-by: Maxime Ripard <maxime at cerno.tech>
>> This patch landed in linux-next as commit 864c49a31d6b ("drm/bridge:
>> adv7511: Register and attach our DSI device at probe"). Sadly it causes
>> endless probe-fail-defer loop on DragonBoard 410c board
>> (arch/arm64/boot/dts/qcom/apq8016-sbc.dts):
> I'm sorry to hear that (but would have been surprised if it didn't occur)
>
> This is supposed to be fixed by 8f59ee9a570c ("drm/msm/dsi: Adjust probe
> order"). Do you have that patch applied?

Yes, I did my test directly on linux next-20211028, which also contains 
it. What might be important in my case, my DragonBoard 410c doesn't have 
any display attached.

I've also noticed the following error during boot:

[   23.847651] msm_mdp 1a01000.mdp: Adding to iommu group 3
[   23.866044] msm_mdp 1a01000.mdp: No interconnect support may cause 
display underflows!
[   23.957949] irq: no irq domain found for mdss at 1a00000 !
[   23.958014] msm_dsi 1a98000.dsi: failed to request IRQ0: -22
[   23.962229] msm_dsi: probe of 1a98000.dsi failed with error -22

The above errors appeared in next-20211028 for the first time. I assume 
that they are related.

Best regards
-- 
Marek Szyprowski, PhD
Samsung R&D Institute Poland