[Freedreno] [PATCH v4] phy: qcom-qmp: add support for display port voltage and pre-emphasis swing

[Stephen Boyd]

Quoting Kuogee Hsieh (2021-09-14 09:45:01)
> Both voltage and pre-emphasis swing level are set during link training
> negotiation between host and sink. There are totally four tables added.
> A voltage swing table for both hbr and hbr1, a voltage table for both
> hbr2 and hbr3, a pre-emphasis table for both hbr and hbr1 and a pre-emphasis
> table for both hbr2 and hbr3. In addition, write 0x0a to TX_TX_POL_INV is
> added to complete the sequence of configure dp phy base on HPG.
>
> Chnages in v2:
> -- revise commit test
> -- add Fixes tag
> -- replaced voltage_swing_cfg with voltage
> -- replaced pre_emphasis_cfg with emphasis
> -- delete drv_lvl_reg and emp_post_reg parameters from qcom_qmp_v4_phy_configure_dp_swing()
> -- delete drv_lvl_reg and emp_post_reg parameters from qcom_qmp_phy_configure_dp_swing()
>
> Changes in V3:
> -- add __qcom_qmp_phy_configure_dp_swing() to commit swing/pre-emphasis level
>
> Changes in V4:
> -- pass 2D array to __qcom_qmp_phy_configure_dp_swing()
>
> Fixes: aff188feb5e1 ("phy: qcom-qmp: add support for sm8250-usb3-dp phy")
> Signed-off-by: Kuogee Hsieh <khsieh at codeaurora.org>
> ---

Reviewed-by: Stephen Boyd <swboyd at chromium.org>